Справочник Пользователя для Itron Inc. 100GDLAN
Elster American and Itron Actaris Commercial Meter Installation
TDC-0823-005 100G Datalogging Installation Guide - Direct Mount
58
Proprietary and Confidential
2. Align the endpoint so the screw holes line up with the meter's top screw holes. Carefully lower the
endpoint on the meter with the wriggler notches lining up with the meter's wriggler teeth.
Warning The INLET label on the 100G Datalogging commercial gas endpoint must line up
with the INLET label on the meter case.
with the INLET label on the meter case.
3. Verify the bottom of the endpoint and the top of the meter meet. The endpoint housing should rest on top
of the meter without gaps.
Warning Do not press down on the 100G Datalogging commercial gas
endpoint if a gap exists between the endpoint and the meter. A gap may be
caused by misalignment of the endpoint wriggler and meter wriggler's drive
teeth. Pushing down on the endpoint could damage the endpoint wriggler or
meter drive teeth. To eliminate a gap, slowly turn the endpoint's upper
wriggler back and forth until the endpoint aligns with the meter's drive teeth.
endpoint if a gap exists between the endpoint and the meter. A gap may be
caused by misalignment of the endpoint wriggler and meter wriggler's drive
teeth. Pushing down on the endpoint could damage the endpoint wriggler or
meter drive teeth. To eliminate a gap, slowly turn the endpoint's upper
wriggler back and forth until the endpoint aligns with the meter's drive teeth.
4.