Справочник Пользователя для DEI Headquarters Inc. DEI7752
31
© 2008 Directed Electronics. All rights reserved.
If the alarm is triggered when armed.
•
When the Remote Start command is sent again from a remote
•
control
➤
Runtime Check
To check the amount of runtime remaining (2 way remote only):
After the vehicle is remote started, press the
After the vehicle is remote started, press the
AUX
button three-times and
then hold until the remote beeps, and then release. The display will
show a text indicating remaining run time.
show a text indicating remaining run time.
➤
Manual transmission
If the vehicle has manual transmission the proper steps must be fol-
lowed before leaving the parked vehicle or the remote start feature is
disabled.
lowed before leaving the parked vehicle or the remote start feature is
disabled.
Put the transmission in neutral.
1.
Press on the vehicle’s foot brake.
2.
Apply the emergency brake.
3.
Release the vehicle’s foot brake.
4.
Note:
Pressing the brake again
after this step will disable the remote start feature.
Within 15 seconds activate the remote start from the remote.
Within 15 seconds activate the remote start from the remote.
5.
The parking lights will flash 5 times confirming that the remote start
6.
is active.
Turn off the ignition (the car should stay running when key is turned
Turn off the ignition (the car should stay running when key is turned
7.
off).
Exit the vehicle and close the door.
Exit the vehicle and close the door.
8.
Arm the alarm (the vehicle should shut off when arming the sys-
9.
tem).
You can now remote start the vehicle. If a door is opened or if the alarm