Справочник Пользователя для Ione RFCOMBOSCM7ITR
Gemini MI (P)
13
Setup for linkage
Reset ID before using
Step 1: Connect the receiver to your computer
Step 2: Push the button on the back of the mouse (in upper left corner).
Step 3: Push the “CONNECT” button on the receiver. Please note that this
Step 1: Connect the receiver to your computer
Step 2: Push the button on the back of the mouse (in upper left corner).
Step 3: Push the “CONNECT” button on the receiver. Please note that this
step must be completed after Step 2 within 8 seconds.
Step 4: Move pointer, when the receiver and the mouse are connected,
the LED will blink, the setting has been completed.
Step 5: Please go back to Step 2 if the LED does not behave as that in
Step 4.
Step 6: Push the button on the back of the keyboard (in upper left
corner).
Step 7: Push the “CONNECT” button on the receiver. Please note that this
step must be completed after Step 6 within 8 seconds.
Step 8: Push “Space” key, when the receiver and the keyboard are
connected, the LED will blink, the setting has been completed.
Note: If same ID is used by other users and causes interference, just
repeat this reset procedure.