Справочник Пользователя для Ione RFLYNXP22U
Reset ID before using
Step 1: Plug the RF Receiver in your computer (PS2 port or USB port). For best
result, please plug the RF Receiver in the Front Side USB Port or use the
USB Extension Cable we provided.
USB Extension Cable we provided.
Step 2: Push the connect button on the RF Receiver. The Signal LED will start to
blink.
Step 3: Push the connect button on the back of the Wireless Mouse. Please note
that this step must be completed within 8 seconds after Step 2.
Step 4: When the RF Receiver and the Wireless Mouse are connected, the Signal
LED will blink faster for a while, it means ID set has been completed.
If the Wireless Mouse does not work properly, please go back to Step 2.
(In case, the ID is used by other users or devices, please just repeat this
reset procedure.)
reset procedure.)
Now, Enjoy and Have Fun !!!!
TROUBLE SHOOTING GUIDE
Symptom Possible
Reason
Remedy
Follow the step of ID reset
to connect device and
receiver again.
to connect device and
receiver again.
Plug the device to PC host
port or a USB Hub with
power support.
port or a USB Hub with
power support.
Can't recognize the device
or the device can't work.
or the device can't work.
Device can't connect to
receiver
receiver
Follow the step of ID reset
to connect device and
receiver again.
to connect device and
receiver again.
Device can't work after
the driver be installed or
removed.
the driver be installed or
removed.
The Driver be installed or
removed.
removed.
Reboot the PC.
The function of software
is not work.
is not work.
Function error.
Re-install the software or
refer the User's Guide.
refer the User's Guide.