Справочник Пользователя для B+B SmartWorx WLNG1
Operate the All-in-One
26
Turn off the All-in-One
To turn off the All-in-One, press and hold the green Power button for three seconds.
IMPORTANT:
Turn off the All-in-One before disconnecting the battery cable.
Remove the All-in-One and wrist case
1.
After turning off the All-in-One, grasp the battery cable connector and pull straight out.
IMPORTANT:
Do not pull on the battery cable; pull on the battery cable connector that is plugged
into the battery.
2.
Release the fastener ends of the finger strap.
3.
Loosen the finger strap by rotating the front buckle (finger strap buckle) outward about 90
degrees, and then pulling the strap free through the buckles with your fingers. Repeat on the
buckle on the other side until the All-in-One is loose enough to easily slide your fingers out.
degrees, and then pulling the strap free through the buckles with your fingers. Repeat on the
buckle on the other side until the All-in-One is loose enough to easily slide your fingers out.
4.
Loosen the wrist strap until the hand can slide out freely.
5.
Slide the hand and fingers backwards out of the All-in-One.
6.
Release and loosen the wrist case straps and slide the wrist case off the arm.