Справочник Пользователя для Digital Security Controls Ltd. 01NB5132

4

This section describes how to enroll wireless devices (WLS904-433, WLS906-
433  and WLS925-433), and wireless keys (WLS909-433). For more information
on these devices, read the instruction sheet included with each device.

An electronic serial number (ESN) is printed on the back of each wireless device.
ESNs are used to enroll the wireless devices with the PC5132 receiver.

In order to reduce the occurrence of wireless devices with the same serial
number, 6-digit serial numbers are now printed on the back of each wireless
device. The 6-digit serial numbers include hexadecimal digits. For instructions
on programming hexadecimal numbers, see your system Installation Manual,
section 4: How to Program.

NOTE: 6-digit serial numbers are only supported on the following control panels:
PC501X,  PC1555 and PC580 v2.0 and higher.

The WLS904-433, WLS906-433 and WLS925-433 devices have both a 5-digit
and a 6-digit serial number printed on them. When connecting the PC5132 to a
PC5010 v1.x panel, enter 5-digit serial numbers only. When connecting the
PC5132 to a PC5015 v2.x and higher, PC5010, PC1555, or PC580 panel enter
the 6-digit serial number.

1. At a system keypad, enter [✱][8][Installer’s code] to go to the installer’s

programming section.

2. Enter programming section [804].
3. Enter the 2-digit number corresponding to the zone the device is to

occupy ([01] to [32]).

NOTE: Hardwired and wireless devices cannot be assigned to the same zone.
PC5108 zone expander modules occupy zones in 2 groups of 4 (e.g. zones 9-
12 and zones 13-16). None of the zones assigned to a PC5108 module may be
used for wireless devices. For more information on zone assignment, consult
your system Installation Manual.

4. Enter the device’s ESN. Follow the instructions in section 3.1 above.
5. Record the serial number and the assigned zone number in the

programming worksheets in the back of this manual.

6. Continue with steps 3 - 5 until you have enrolled all wireless devices.
7. To exit press [#]. The device is now enrolled on the system.

NOTE: The devices will not work properly until you complete zone and partition
programming (see section 4).

Enrolling Wireless Devices