Справочник Пользователя для Wulfsberg Electronics Division 2000-UHF1
Wulfsberg Electronics
P-2000 and C-2000/RT-2000 Operator’s Manual
Document 150-041102 Revision A
Page 14 of 37
Receiving/Transmitting
Transmitting
To transmit on a radio system, select the appropriate source on your audio panel, and key the microphone.
Transmission will begin on the radio’s currently selected Active Channel. During the transmission, the radio’s
transmit indicator will light, and the channel’s transmit frequency will be displayed. The following illustration
depicts FM #1 transmitting.
Transmission will begin on the radio’s currently selected Active Channel. During the transmission, the radio’s
transmit indicator will light, and the channel’s transmit frequency will be displayed. The following illustration
depicts FM #1 transmitting.
Receiving
The P-2000 is constantly monitoring its radios for reception. When a signal is received, the P-2000 will light the
receive indicator for the receiving radio, and route the audio to the operator’s headset (assuming the associated
intercom switch is selected). The following illustration depicts FM #2 receiving.
receive indicator for the receiving radio, and route the audio to the operator’s headset (assuming the associated
intercom switch is selected). The following illustration depicts FM #2 receiving.
Enabling/Disabling Transceivers
Transceivers cannot be individually powered off on the P-2000, however the volume level of either transceiver can
be reduced to zero, effectively turning off the transceiver. The screen below shows what the display looks like when
the audio level of a transceiver is set to zero. Notice the mute indicator is displayed and the level indicator turns red.
be reduced to zero, effectively turning off the transceiver. The screen below shows what the display looks like when
the audio level of a transceiver is set to zero. Notice the mute indicator is displayed and the level indicator turns red.
RX Indicator
TX Indicator