Справочник Пользователя для Everspring Industry Co Ltd TSA04
Iris Smart Keypad – Quick Start Guide v1.0
Matt Stratfold ‐ Monday, 12 March 2012
Installing your Iris Smart Keypad
Your new keypad needs to be added to an Iris system. Follow the instructions below depending on
whether this is an upgrade to an existing system, or you are installing your keypad as part of a new
Iris system.
whether this is an upgrade to an existing system, or you are installing your keypad as part of a new
Iris system.
Do not insert the batteries into your keypad until instructed to do so by the onscreen instructions.
Adding your Iris Smart Keypad to an existing Iris system:
1. Log into your Iris dashboard and click the ‘devices’ link.
2. Select ‘add devices’
3. Follow the on screen instructions
Adding your Iris Smart Keypad to a new Iris system:
1. Follow the installation guide that was supplied with your Iris Smart Hub.
2. The onscreen installation process will ask which devices you have. Make sure that the
keypad is selected.
3. The onscreen instructions will describe the steps to add your keypad.
Mounting and positioning
Position the keypad in a convenient location, inside your home and near an entry door. Use the
enclosed screws to attach the mounting bracket to the wall.
enclosed screws to attach the mounting bracket to the wall.
Setting up a PIN
The PIN you chose when Iris was installed is the default PIN for controlling your system. You can
change this PIN online in Iris the account page. You may allocate PINs for family members, friends
and service personnel; visit the ‘contacts’ section online to do this. Iris will keep a log of each time
one of these PINs has been used.
change this PIN online in Iris the account page. You may allocate PINs for family members, friends
and service personnel; visit the ‘contacts’ section online to do this. Iris will keep a log of each time
one of these PINs has been used.
Using your Iris Smart Keypad
The intruder alarm can be set to secure your home when you leave by pressing and holding the ‘on’
or ‘partial’ buttons for two seconds. The light for the selected mode will illuminate for a few seconds
to confirm the mode change. Depending upon your settings the keypad may beep for a short while
before being fully set. This permits you time to leave your home before the alarm is active.
or ‘partial’ buttons for two seconds. The light for the selected mode will illuminate for a few seconds
to confirm the mode change. Depending upon your settings the keypad may beep for a short while
before being fully set. This permits you time to leave your home before the alarm is active.
The panic alarm may be triggered by pressing the ‘panic’ button for two seconds.
To turn your alarm off enter your four digit PIN and press the ‘off’ button.
You may cancel a ringing alarm by entering your PIN and pressing the ‘off’ button.