Справочник Пользователя для Suncon Toys Industry Ltd 60202R

©2007. 

RadioShack Corporation. 

All rights reserved. 

RadioShack and 

RadioShack.com are trademarks 
used by 

RadioShack Corporation.

60-155A

05A07

Printed in China

1.  Turn off your truck. 
2.  Insert one 9V battery (not supplied) in the 

transmitter battery compartment matching 
the polarity symbols (+ and -) marked inside.

3.  On the truck, turn the latches to open the 

battery compartment. 

4.  Load six AA batteries (not supplied) with 

correct polarity into the supplied battery 
compartment tray

OR
  Load and connect a fully-charged 9.6V 

battery pack (not supplied). The connector

The connector 

fits only one way. Do not force it.

5.  Replace the battery door and secure the 

latches.

•  Use only fresh batteries of the required 

•  Do not use your truck near transmitters 

with the same frequency (27 MHz or 49 
MHz).

•  A nearby CB can interfere with your truck’s 

control. If this happens, move the truck 
away from the CB.

•  Never play with your truck in the street.
•  Avoid high-impact collisions with people 

and objects.

This equipment has been tested and found to comply with the limits 

for a Class B digital device, pursuant to Part 15 of the FCC Rules. 

These limits are designed to provide reasonable protection against 

harmful  interference  in  a  residential  installation.  This  equipment 

generates, uses, and can radiate radio frequency energy and, if 

not installed and used in accordance with the instructions, may 

cause  harmful  interference  to  radio  communications.  However, 

there is no guarantee that interference will not occur in a particular 

installation. If this equipment causes harmful interference to radio 

or television reception, which can be determined by turning the 

equipment off and on, the user is encouraged to try to correct the 

interference by one or more of the following measures: 

•  Reorient or relocate the receiving antenna. 

•  Increase the separation between the equipment and receiver. 

•  Connect  the  equipment  into  an  outlet  on  a  circuit  different 

from that to which the receiver is connected. 

•  Consult  your  local  RadioShack  store  or  an  experienced 

technician for help. 

If  you  cannot  eliminate  the  interference,  the  FCC  requires  that 

you stop using your truck. Changes or modifications not expressly 

approved by RadioShack may cause interference and void the 

user’s authority to operate the equipment. 
This  device  complies  with  Part  15  of  the  FCC  Rules.  Operation 

is  subject  to  the  following  two  conditions:  (1)  This  device  may 

not cause harmful interference, and (2) This device must accept 

any interference received, including interference that may cause 

undesired operation.  

This product is warranted by RadioShack against manufacturing 

defects in material and workmanship under normal use for ninety 

(90) days from the date of purchase from RadioShack company-

owned stores and authorized RadioShack franchisees and 

dealers. For complete warranty details and exclusions, check with 

your local RadioShack store.

RadioShack Customer Relations

300 RadioShack Circle

Fort Worth, TX 76102 

 

 

04/04

www.radioshack.com

R / L – Turn toward R if the truck pulls to the 

left, or toward L if it pulls to the right.

L / H – Switch to L when driving on rough 

terrain, or to H when driving on smooth terrain.

Make sure the transmmitter andd the vechicle are 

on the samme band.

1.  Thread the truck’s antenna wire through the supplied antenna tube. Then, insert the tube 

into the antenna tube holder on the truck’s body.

2.  Make sure the transmitter and the truck are on the same band. Turn on the truck and 

transmitter. Your truck comes in 3 frequencies(ABC) so you can play with friends. Set your 
truck and transmitter to a frequency different to your friend’s.

3.  Use the transmitter’s control levers to steer your truck.
4.  Turn off the truck when you finish driving.

60-155A.indd   1

05/24/2007   17:46:00