Справочник Пользователя для Tekk XT400
Once Scan starts, LED will flash in order of the following step
repeatedly as below
RED ==? GREED ===? Orange
It indicates that Scan is on progress.
To stop scanning, Press Scan button again for a two seconds,
Radio will go back to the original channel used before start a scan
and then radio stops flashing LED.
If a conversation is detected a correct call, radio will stop on that
channel and user will be able to hear the conversation. If
programmed for normal scan TX, you will be able to transmit on
that active channel during the programmable scan delay time. The
scan delay time is the amount of time. Radio will stay on that
channel once activity has cased. The radio will resume scanning
once the scan delay time has expired. Scanning will continue until
the channel is changed or press scan button again.
repeatedly as below
RED ==? GREED ===? Orange
It indicates that Scan is on progress.
To stop scanning, Press Scan button again for a two seconds,
Radio will go back to the original channel used before start a scan
and then radio stops flashing LED.
If a conversation is detected a correct call, radio will stop on that
channel and user will be able to hear the conversation. If
programmed for normal scan TX, you will be able to transmit on
that active channel during the programmable scan delay time. The
scan delay time is the amount of time. Radio will stay on that
channel once activity has cased. The radio will resume scanning
once the scan delay time has expired. Scanning will continue until
the channel is changed or press scan button again.
- Scan channel Delete : To temporarily delete a channel from the
scan list,
simply press the scan button for a short time while stopped on
the channel
to be detected. This will remove that channel from the scan list
until the
channel is changed or the radio’s power is reset. When power is
restored
or the scan list channel position is again selected, the original
dealer
programmed scan list will be activated.
scan list,
simply press the scan button for a short time while stopped on
the channel
to be detected. This will remove that channel from the scan list
until the
channel is changed or the radio’s power is reset. When power is
restored
or the scan list channel position is again selected, the original
dealer
programmed scan list will be activated.
- Priority Scan On : A single channel is programmed as the “
Priority” channel.
The radio will constantly monitor this channel with flashing LED
while scanning and when the radio has stopped on an active
channel. If a call is detected on the “priority” channel, the radio
will automatically move to, and remain on the “ Priority” channel
as long as the priority conversation takes places. “priority”
channel activity takes precedence over all other conversations.
while scanning and when the radio has stopped on an active
channel. If a call is detected on the “priority” channel, the radio
will automatically move to, and remain on the “ Priority” channel
as long as the priority conversation takes places. “priority”
channel activity takes precedence over all other conversations.
- Priority Scan Off : To be out of “Priority scan” Just change
Channel.