Справочник Пользователя для Climax Technology Co Ltd 1818
9
Step 7. Turn the Camera Angle Knob counter-clockwise (as shown in the picture below)
to loosen the Camera Mount Screw from the Cap.
Step 8. Screw the Camera Mount Screw into the Camera Stand Mounting Hole of the
IP Camera (by turning the Camera Locking Collar counter-clockwise).
Step 9. Find a desired angle for the IP Camera and turn the Camera Angle Knob
clockwise to stabilize the Camera Mount Screw.
When tightening the camera angle knob, please make sure the Cap of the Head is
attached to the cap fitting without leaving any gap as shown in the picture on the left:
If there is a gap between the cap and the cap fitting as shown in the picture on the right,
the top screw shaft cannot be stabilized and the camera angle cannot be fixed.
Pushed in correctly
Not pushed in