Справочник Пользователя для DTC Communications Inc. PD2TX1000S
3
NOTE: Describes special issues you should be aware of
while using a particular function.
while using a particular function.
WARNING: Calls out situations in which
equipment could be damaged or a process could be
incorrectly implemented, but in which operator safety is
not a factor.
equipment could be damaged or a process could be
incorrectly implemented, but in which operator safety is
not a factor.
TIP: Describes application hints.
RF EXPOSURE STATEMENT
A separation distance of at least 20 cm must be
maintained between the antenna and the body of
the user or nearby persons. When the unit is used
consistent with the previous notice, it conforms to
the requirements of FCC Rules & Regulations, sections
1.1307 & 2.1091, as required by section 90.1217.
maintained between the antenna and the body of
the user or nearby persons. When the unit is used
consistent with the previous notice, it conforms to
the requirements of FCC Rules & Regulations, sections
1.1307 & 2.1091, as required by section 90.1217.
CAUTION! Use of antennas with gain above 2.1 dBi may
exceed Maximum Permissible Exposure (MPE) limits.
exceed Maximum Permissible Exposure (MPE) limits.
NOTE: This device is for occupational use only.
Occupational users are those persons who are exposed
as a consequence of their employment, provided these
persons are fully aware of and exercise control over
their exposure.
Occupational users are those persons who are exposed
as a consequence of their employment, provided these
persons are fully aware of and exercise control over
their exposure.
NOTE: DO not allow the device to directly contact the
skin due to warm operating temperatures.
skin due to warm operating temperatures.
manual conventions
Quick Start
....................................................................................................................4-5
Accessories
........................................................................................................................ 5
Introduction ........................................................................................................................ 6
Operation
Operation
........................................................................................................................ 7
Using your Palladium II Transmitter .............................................................................. 7
Changing your Transmitter Configuration ................................................................. 7
Heat Sink
Changing your Transmitter Configuration ................................................................. 7
Heat Sink
....................................................................................................................8-9
Components .............................................................................................................. 10-11
Programming ......................................................................................................................11
Specifications .............................................................................................................. 12-13
Notes
Programming ......................................................................................................................11
Specifications .............................................................................................................. 12-13
Notes
......................................................................................................................14
Contact Us
......................................................................................................................15
TABLE OF CONTENTS