Справочник Пользователя для Philips Consumer Lifestyle DC912V37SW

15

1

Press SOURCE repeatedly (or TUNER on the
remote control) to select the tuner source (FM).

2

Hold 

S

/

T

 on the system (or TUNING +/-

on the remote control) and then release the
button.

➜

The system will start searching for a radio

station with sufficient signal strength.

3

Repeat step 2 if necessary until you find the
desired station.

●

To tune to a weak station, press 

S

/

T

 on

the system (or TUNING +/- on the remote
control) briefly and repeatedly until you have
found optimal reception.

You can store up to a total of 40 radio stations
(40 FM) in the memory.

Automatic programming will start with a chosen
preset number. From this preset number
upwards, former programmed radio stations will
be overridden.

1

Press PRESET +/- on the system (or ALBUM/
PRESET 3 / 4 on the remote control) to
select the preset number where programming
should start.

2

Press PROG on the remote control for more
than two seconds to activate programming.

➜

All available stations are programmed.

1

Tune to your desired station (refer to “Tuning to
radio stations”).

2

Press PROG on the remote control to activate
programming.

➜

PROG appears in the display.

3

Press PRESET +/- on the system (or ALBUM/
PRESET 3 / 4 on the remote control) to
allocate a number from 1 to 40 to this station.

4

Press PROG on the remote control again to
confirm the setting.

➜

PROG disappears, the preset number and

the frequency of the preset station are shown.

5

Repeat the above four steps to store other
stations.

●

You can override a preset station by storing
another frequency in its place.

●

Press PRESET +/- on the system (or ALBUM/
PRESET 3 / 4 on the remote control) until
the desired preset station is displayed.

 

pg001-024_DC912_37_Eng

2/27/08, 14:46

15