Справочник Пользователя для Scientific Toys Ltd 2782-27SH

1. Plug the wall pack battery charger into wall  
 outlet.
2. Connect the cables leading from the battery  
  pack and charger together by snapping the  
  jack and the socket tightly. (See Diagram 1)
3. To disconnect cables, press down on the clip 
  and pull apart. (See Diagram 1)
4. You should charge the battery pack for 8  
  hours the first two times. Then subsequent  
  charges will only require minimum 4 hours. 
5. After charging for 4 hours, the battery pack 
  will be warm. This condition is normal for fully 
  charged batteries. If the speed of the car  
  slows down suddenly, it is time to recharge.
6. After use, the battery pack will be hot! Wait at 
  least 20 minutes until it cools before recharging.
7. Recharging a warm or hot battery pack will 
  greatly shorten battery life.

1. If battery pack and/or connectors are wet,  
  thoroughly dry before charging.
2. Unplug the battery pack if it is not going to be  
  used for several days.
3. Do not mix old and new batteries.
4.  Do not mix alkaline, standard (carbon-zinc), 
  or rechargeable (nickel-cadmium) batteries.
5. Do not charge battery pack that is hot, wet
  or shows leakages or corrosion. 

A. Make sure the ON/OFF switch is in the 
  “OFF” position. (See Diagram 2) 
B. Turn the lid stopper in a clockwise direction 
  to open battery lid. (See Diagram 3)
C. Lift the battery lid to open and place the  
  battery pack inside properly. (See Diagram 3)
D. Plug the jack of the battery pack into the 
  socket of the battery compartment.
  (See Diagram 3)
E. Replace the battery cover. 

A. Pass the cable through the antenna tube  
  provided and plug into the vehicle tightly.  
  (See Diagram 5)
B. Screw the antenna onto the top of the  
  transmitter and extend to full length. 
  (See Diagram 6)
C. Push the ON/OFF switch to the “ON”  
  position. (See Diagram 2)

D.  Pull the trigger of the transmitter back
 

(towards you). (See Diagram 7)

E.  Push the trigger of the transmitter forward 
 

(away from you). (See Diagram 8)

A. Unscrew the battery cover at the bottom of 
the transmitter and place a 9-volt battery inside 
following the engraved signs (See Diagram 4).

PRESS HERE 

WHEN OPENING

BATTERY 
CHARGER

9.6V Ni-Cd 

BATTERY PACK

ON/OFF SWITCH

LID 

STOPPER

BATTERY LID

9.6V Ni-Cd 

BATTERY PACK

TURNS TO THE 

CLOCKWISE 

DIRECTION

FORWARD

REVERSE

ANTENNA

TUBE

CABLE

© 2005 SCIENTIFIC TOYS, LTD.

CHAI WAN, HONG KONG.

PRINTED IN CHINA

O.I.NO.0001

Not recommended for children under 6 years of age. As

with all electric products, precautions should be observed

during handling and use to prevent electric shock.

INPUT: 120VAC-60Hz-5.5W ONLY 

OUTPUT: 12VDC, 0.2A 

STEERING 

ALIGNMENT 

LEVER

STOP

2. Adjust the transmitter to match the band 
  selected for the car. For example, if Band 
  2 is selected for the car, slide the band 
  switch of the transmitter to Band 2. 
3. Select a different band for each pair of car 
  and transmitter and go racing. 
  (See diagram 15)

TIPS FOR THE MULTI-PLAYER CONTROL 
SYSTEM
1. When operating multiple cars, only one 
  pair of car and transmitter shall be using 
  the same band. Interference may occur if i) 
  more than one car is set to the same band;
  or ii) more than one transmitter is set to the 
 same 

band.

2. If a car does not respond, check the 
  transmitter and the car to ensure that both
  are set to the same band.
3. The Multi-Player Control System allows 
  multiple cars within the collection to be 
  raced at the same time.  Use of other radio
  control products that are not part of this 
  Multi-Player Control System may cause 
  interference and loss of control to the cars.

•  Do not drive car on grass, sand or carpet.
•  Do not drive car through water.
•  Be sure to rest your vehicle for at least
  30 minutes after every 15 minutes 
 of 

operation.

•  Make sure ON/OFF switch on your vehicle 
  is in the “OFF” position when it is not in use.

4

5

6

1

2

3

•  Do not bend the antenna.
•  Electrical, CB interference, mobile phones, 
  air conditioning, elevators and steel girders 
  in buildings will affect the operation of 
 your 

vehicle.

•  Do not leave the vehicle or transmitter near 
  sources of heat or in direct sunlight for 
  long periods of time.
•  Remove the batteries from the vehicle and
  transmitter when they are not in use.

 

 

6. Do not expose to fire, as explosion may result.
7. Do not disassemble the battery pack. 

B. Replace the battery cover.

F. If the vehicle does not run straight forward,
  adjust the lever for satisfactory alignment on
  the underside of the vehicle. (See Diagram 9)
G. If the vehicle runs toward left, turn "Steering
  Alignment Lever" towards "R."
H. If the vehicle runs toward right, turn "Steering
  Alignment Lever" towards "L."

I.  To make left or right-hand turns while driving 
  forward, turn the steering wheel to left or right 
  while pulling the trigger of the transmitter back 
  (towards you). (See Diagram 10)
J. To make left or right-hand turns while driving in
  reverse, turn the steering wheel to left or right 
  while pushing the trigger of the transmitter 
 forward 

(away from you). (See Diagram 11)

K. Release the trigger to stop. 
  (See Diagram 12).

Collect multiple Multi-Player Control System 
vehicles to run up to 6 cars at the same time.  
1. Assign a different band to each car.  The 6 
  available bands are Band 1, Band 2, and 
  Band 3 for 27MHz (See diagram 13); Band 
  4, Band 5, and Band 6 for 49 MHz 
  (See diagram 14).

 

BOTTOM OF

TRANSMITTER

9-VOLT

BATTERY

BATTERY COVER

TRIGGER

PULL THE

TRIGGER

PUSH THE

TRIGGER

STEERING 

WHEEL

STEERING 

WHEEL