Справочник Пользователя для Seiko Instruments AB000003
-
21
-
6 FUNCTION SETTING
This printer can be set various function according to operating conditions or uses.
The settings are stored in the software DIP switches (hereinafter referred to as “SWDIP
switch”) in the FLASH memory of printer. They can be set by using switches or by
entering commands.
This manual describes how to set functions by using switches.
The settings are stored in the software DIP switches (hereinafter referred to as “SWDIP
switch”) in the FLASH memory of printer. They can be set by using switches or by
entering commands.
This manual describes how to set functions by using switches.
NOTE
- Be sure to set the directed value as "Fixed" according to 0 or 1 in list so
that the printer works correctly.
that the printer works correctly.
HINT
See the Technical Reference for details on function setting with
commands.
Function Setting Mode
The printer must be in the function setting mode to set functions with switches.
To enter the function setting mode, do as follows:
(1) Make sure that the thermal paper is set in the printer and the printer is turned off. If
To enter the function setting mode, do as follows:
(1) Make sure that the thermal paper is set in the printer and the printer is turned off. If
the thermal paper is not set, set the thermal paper as described in Section 4, Paper
Setting, and then turn the printer off.
Setting, and then turn the printer off.
HINT
If an error occurs in the function setting mode, the POWER and ERROR
lamps blink 3 to 4 times and the power is turned off.
(2) Press the POWER and FEED switches at the same time. When the POWER lamp
and the ERROR lamp light, and six seconds later the POWER and ERROR lamps
start blinking, release your fingers from both of the switches.
start blinking, release your fingers from both of the switches.
(3) If the message shown at the following is printed, press the FEED switch.
Select Function
Setting Mode
Setting Mode
: Feed SW
HEX Dump Mode : Power SW