Справочник Пользователя для Tait International Limited TBCK4A
TB9400 Installation and Operation Manual
Replacing Modules
117
© Tait Limited March 2015
8.7
Replacing the Subrack Interconnect Board
Removal
1.
If you have not already done so, carry out the instructions in
2.
Disconnect any system control bus cables and DC power cables
from the subrack board.
from the subrack board.
3.
Remove the three M3 nuts and spring washers
b
securing the right
end of the board to the subrack.
4.
Remove the D-range cover
c
.
5.
Remove the two retaining clamps
d
securing the left end and centre
of the board.
6.
Remove the board.
Refitting
1.
If previously removed, replace the insulator
e
.
2.
Refit the board and D-range cover, and secure with the M3 nuts and
spring washers. Replace the two retaining clamps.
spring washers. Replace the two retaining clamps.
3.
Reconnect the system control bus cables and reciter DC cables as
shown in
shown in
“Appendix B – Inter-Module Connections” on page 117
).
Figure 8.1
Replacing the subrack interconnect board
b
e
c
d
x3