Справочник Пользователя для Digital Monitoring Products Inc PC0103

6. Gently slide the PCB back into the housing making sure the lever alarm switch is in position to activate.  See 

Figure 4.

Correct

Lever Alarm 

Switch Location

Red LED

Antenna

Incorrect

Lever Alarm 

Switch Location

Red LED

Antenna

7. Use a Phillips screwdriver to replace the base onto the housing.
8. Slide the bill trap back into the cash drawer. 

  Caution: Properly dispose of unused batteries.  Do not recharge, disassemble, heat above 212°F (100°C), or 

 

incinerate.  Risk of fire, explosion, and burns. 

Typical battery life expectancy for DMP Model 1139 Bill Trap is 1 year.  DMP wireless equipment uses two-way 

communication to extend battery life.  
The following situations can reduce battery life expectancy:

•  If a receiver is unplugged, too far away, or not installed.  

Note: Transmitters continue to send supervision messages until a receiver returns an acknowledgement.  

After an hour the transmitter only attempts a supervision message every 60 minutes.

•  Frequent transmissions, such as constant removing and replacing the trapped bill.
•  When installed in extreme hot or cold environments.

The following situation can extend battery life expectancy:

•  Extend transmitter supervision time in panel programming.
•  Infrequent transmission trips.