Справочник Пользователя для Digital Monitoring Products Inc PC0117

 

The enclosure for the XTL panel must be mounted using the provided #6 screws in the four mounting holes

shown in Figure 2. Mount the enclosure in a secure, dry place to protect the panel from damage due to

tampering or the elements. It is not necessary to remove the PCB when installing the enclosure.

65555

RESET

S1

LOAD

S2

BAT

J1

PROG

RED

PWR

MODEL XTL

Mounting Hole

Locations

TX  RF  RX

Mount the XTL panel near a wall outlet for the Model 372-500 plug-in DC power supply. In addition to

powering the panel, the DC plug-in power supply also charges the back-up battery. The 372-500 must be

located within 100 feet of the panel using 22 AWG wire or 250 feet using 18 AWG wire. Use the following

steps to connect the plug-in power supply:

1. Using 18 or 22 AWG wire, connect the panel PWR (J2) first terminal (+) to the positive terminal on

the power supply.

2. Connect the panel PWR (J2) second terminal (-) to the negative terminal on the power supply.
3. Plug the power supply into a 110 Volt AC dedicated outlet not controlled by a switch.

65555

RESET

S1

LOAD

S2

BAT

J1

PROG

RED

PWR

MODEL XTL

Wire Exits for DC 

Power Supply

TX  RF  RX

Model 372-500

DC Plug-in

Power

Supply

Use 18 AWG or 22 AWG for 

Power Supply connection