Справочник Пользователя для Digital Monitoring Products Inc PC0123R8

8 0 0 - 6 4 1 - 4 2 8 2

I N T R U S I O N   •   F I R E   •   A C C E S S   •   N E T W O R K S

w w w . d m p . c o m

2 5 0 0   N o r t h   P a r t n e r s h i p   B o u l e v a r d

Designed, Engineered and 

Manufactured in Springfield, Missouri

S p r i n g fi e l d ,   M i s s o u r i   6 5 8 0 3 - 8 8 7 7

LT

-1106  1.06  © 2016 Digital Monitoring P

roducts, Inc.

16255

When setting up a wireless system, it is recommended to program the siren's output number in the panel and connect 

the receiver before installing the siren's batteries. Battery life expectancy for the 1135 wireless siren is 3 years when 

the siren is operated for five minutes once a month. DMP wireless equipment uses two-way communication to extend 

battery life. To extend battery life further, operate the siren infrequently and extend supervision time in panel 

programming. Multiple on/off siren operations and extreme hot or cold environments will reduce battery life. 
 Observe polarity when installing the batteries. Use only 3.0V Lithium batteries, DMP Model CR123, or the equivalent 

battery from a local retail outlet. For UL installations, only use #123 batteries manufactured by Energizer.
Replacing the Siren Batteries

1. Remove the locking screws from the top and bottom of the siren housing and lift the cover from the bottom to 

remove.

2. Remove the old batteries and dispose of them properly. Always replace both batteries at the same time.

Caution: Do not recharge, disassemble, heat above 212°F (100°C), or incinerate the batteries. There is a risk 

of fire, explosion, and burns with improper disposal.

3. Place the two CR123 batteries in the holders and press into place. See Figure 3 for the battery locations.
4. Set the cover back into place and replace the locking screws.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and 

(2) this device must accept any interference received, including interference that may cause undesired operation.

The antenna used for this transmitter must be installed to provide a separation distance of at least 20 cm (7.874 in.) 

from all persons. It must not be located or operated in conjunction with any other antenna or transmitter.
Changes or modifications made by the user and not expressly approved by the party responsible for compliance could 

void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to 

part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in 

a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed 

and used in accordance with the instructions, may cause harmful interference to radio communications. However, 

there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful 

interference to radio or television reception, which can be determined by turning the equipment off and on, the user is 

encouraged to try to correct the interference by one or more of the following measures:

•  Reorient or relocate the receiving antenna.
•  Increase the separation between the equipment and receiver.
•  Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•  Consult the dealer or an experienced radio/TV technician for help.

Commercial Burglary
The wall tamper must be enabled for commercial burglary applications. Install only on non-conductive surfaces.

Household Fire
Supervision Time must be 3 minutes for fire applications.

Battery 

Life Expectancy  3 Years  

Type 

3.0V Lithium CR123A 

See Siren Battery Power for full details.

Frequency Range  905-924 MHz

Decibel Level 

110 dB at 3 ft.

Dimensions 

4.5” L x 4.5” W x 1.25” H

Color White

Housing Material 

Flame retardant ABS

CR123  

3.0V Lithium Battery

U. S. Patent No. 7,239,236

FCC Part 15 CCKPC0123R8

Industry Canada 5251A-PC0123R8

ANSI/UL 1023 Household Burglar Alarm System Units

ANSI/UL 1610 Central Station Burglar Alarm Units

ANSI/UL 985 Household Fire Warning System