Справочник Пользователя для Rhine Electronics Co Ltd 9040T
PAGE:2-2
GENERAL INFORMATION:
This REMOTE controller is designed to separately control your ceiling fan speed and
light brightness. There are five buttons (Hi,Med,Low,Off,Rev) to control the fan speed
and off. The Light Dimmer button will control the light brightness dimmer and off. The
ON?OFF switch will turn on and turn off the unit’s power supply.
INSTRUCTIONS FOR INSTALLATION AND OPERATION OF FAN SPEED
CONTROLLER
A. Setting the code on your new transmitter.
1.
Slide code switches to your choice of UP and Down position.
Factory setting is all UP. Do not use this setting.
Use ball point pen or small screwdriver.
slide firmly up or down.
Factory setting is all UP. Do not use this setting.
Use ball point pen or small screwdriver.
slide firmly up or down.
B. Setting the code on your new Receiver unit.
1.
Slide code switches to the same positions as set on your transmitter.
They must be set to same positions to work.
They must be set to same positions to work.
2.
Make sure the code switches are on the right positions.
NOTICE:
The changes or modifications not expressly approved by the party responsible for
compliance could void user’s authority to operate the equipment.
This device complies with part 15 of the FCC rules .Operation is subject to the following
two conditions .
(1)This device may not cause harmful interference and (2)This device must accept any
interference received , Including interference that may cause undesired operation .