Справочник Пользователя для Rhine Electronics Co Ltd 9058T
Turn off the power for Fan and Light
GENERAL INFORMATION :
This REMOTE controller is designed to separately control your
ceiling fan speed and light brightness .
ceiling fan speed and light brightness .
INSTRUCTIONS FOR INSTALLATION AND OPERATION OF FAN SPEED
CONTROLLER
CONTROLLER
1. Setting the code on your new transmitter .
Within 60 seconds of turning the AC power on, press and hole the OFF/STOP button for 5 seconds.
The receiver will then lock in the chosen frequency. If your fan has a light it it will blink twice, for
fans without lights check operation using the transmitter
Within 60 seconds of turning the AC power on, press and hole the OFF/STOP button for 5 seconds.
The receiver will then lock in the chosen frequency. If your fan has a light it it will blink twice, for
fans without lights check operation using the transmitter
NOTICE :
The changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
for compliance could void the user’s authority to operate the equipment.
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATIONS IS SUBJECT
INTERFERENCE AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED,
INCLUDING INTERFEERENCE THAT MAY CAUSE UNDESRIED OPERATION.
INTERFERENCE AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED,
INCLUDING INTERFEERENCE THAT MAY CAUSE UNDESRIED OPERATION.
IMPORTANT NOTE:
To comply with the FCC RF exposure compliance requirements, no change to the
antenna or the device is permitted. Any change to the antenna or the device could
result in the device exceeding the RF exposure requirements and void user’s
authority to operate the device.
The term “IC:” before the radio certification number only signifies that Industry Canada Technical
specifications were met.
specifications were met.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to
the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
Le present appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisee aux deux conditions suivantes : (1) l'appareil ne doit
pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioelectrique subi, meme si le brouillage est susceptible d'en compromettre le fonctionnement.
2/2 2013/10/8