Справочник Пользователя для Lectrosonics Inc DB
DSW Digital Wireless System
LECTROSONICS, INC.
14
Mac Installation
Launch your browser and go to:
http://lectrosonics.com/wdsupport/xap/WirelessDe-
signer.html
signer.html
When the Wireless Designer intro screen appears,
right click and choose Install Wireless Designer onto
this computer...
right click and choose Install Wireless Designer onto
this computer...
You may need to install an updated version of Silver-
light before completing the installation.
light before completing the installation.
Connecting to a Network
Using DHCP for IP Address Assignment
Follow these steps to make a network connection for
the receiver:
the receiver:
1) Open Wireless Designer and connect to the
receiver via USB.
2) Click on Settings in the left pane. Then click on
the Network tab in the lower part of the screen.
Inside the dialog box labeled Network Settings,
click on the check box labeled DHCP Enable.
Inside the dialog box labeled Network Settings,
click on the check box labeled DHCP Enable.
3) Close
Wireless Designer.
4) Connect the network cable to the Ethernet port
on the rear panel.
5) Turn the receiver power off then back on.
6) Launch Wireless Designer again and navigate
to Network Settings as described above. The
IP address and port number will appear in the
dialog box.
IP address and port number will appear in the
dialog box.
7) Close the USB connection and re-connect via
network. When the dialog box opens, enter the IP
address and the port number noted, then click on
Refresh. Click on OK to connect.
address and the port number noted, then click on
Refresh. Click on OK to connect.