Справочник Пользователя для Computime Limited RCSIT-TX
50D0098 RCSITE Installation & Operating Manual
Rel 0 Dec 2005
Rel 0 Dec 2005
Page 2 of 10
Ambient Technologies
A Division Of Monessen Hearth Systems
WARNING
Important Safety Information
•
Read this manual thoroughly prior to installing, programming or operating any remote control.
•
This remote control system is designed for use with a millivolt gas valve system. Do not use this remote
control system on applications with voltages above 24 Volts AC/DC and 1 amp current.
control system on applications with voltages above 24 Volts AC/DC and 1 amp current.
•
This remote control system requires three (3) “AAA” alkaline batteries to power the transmitter. The
receiver is powered by four (4) AA Alkaline batteries .
receiver is powered by four (4) AA Alkaline batteries .
•
Wiring must conform to appliance requirement and building codes/ordinances as required by local and
national code authorities having jurisdiction.
national code authorities having jurisdiction.
•
Do not short (or jumper) across the gas valve terminals to test the remote control installation. This could
damage the unit and void the warranty.
damage the unit and void the warranty.
•
This remote control system should only be used as described in this manual. Any other use is not
recommended and will void the warranty.
recommended and will void the warranty.
NOTE
Due to the sensitive temperature monitoring components in the transmitter, it is necessary to
allow the transmitter to stabilize to room temperature before accurate room temperatures are
displayed. If the transmitter is activated from a severe cold condition, allow 15 minutes for
accurate temperature readings to appear on the LCD display.
allow the transmitter to stabilize to room temperature before accurate room temperatures are
displayed. If the transmitter is activated from a severe cold condition, allow 15 minutes for
accurate temperature readings to appear on the LCD display.
WARNING
Turn appliance OFF and allow to cool before installing or servicing. DO NOT connect
110-120 VAC wiring to the milli-volt gas control valve. The remote operator must be installed
exactly as outlined in these instructions. Read all instructions completely before attempting
installation. Follow instructions carefully during installation. Any modification of
components will void the warranty and may cause a fire hazard.
110-120 VAC wiring to the milli-volt gas control valve. The remote operator must be installed
exactly as outlined in these instructions. Read all instructions completely before attempting
installation. Follow instructions carefully during installation. Any modification of
components will void the warranty and may cause a fire hazard.
WARNING
Turn appliance OFF (at the appliance or remote receiver) if you are away from your house
for an extended period of time. Never leave anything on top of the surface of the transmitter.
for an extended period of time. Never leave anything on top of the surface of the transmitter.