Справочник Пользователя для Fukuda Denshi Co Ltd LX7230KM
6. SpO
2
Monitoring (LX-7230N)
21
Reapplication
1. The MAX-I can be reused on the same patient as long as the adhesive
tape attaches without slippage.
2. Enclosed adhesive “dots” are provided for reapplication. Place a
transparent dot over each window as shown, and then remove the
protective paper that covers each dot (Figure (5)). The sensor is now ready
to be reapplied to the same patient. For the reapplication, do not remove
the previous adhesive dot, but place the enclosed adhesive dot over it.
protective paper that covers each dot (Figure (5)). The sensor is now ready
to be reapplied to the same patient. For the reapplication, do not remove
the previous adhesive dot, but place the enclosed adhesive dot over it.
(5)
CAUTION
Precautions for Use of adhesive sensor, MAX-I
Do not reuse the sensor on other patients. This is a sterilized product
and it is intended for single patient use only.
Circulation distal on the sensor site should be checked routinely. The
site must be inspected every 8 hours to ensure adhesion, skin
integrity, and correct optical alignment. If skin integrity changes, move
the sensor to another site
integrity, and correct optical alignment. If skin integrity changes, move
the sensor to another site
Do not use the sensor on patients who exhibit allergic reactions to the
adhesive tape.
Failure to apply the sensor properly may cause incorrect
measurements.
While the sensor is designed to reduce the effects of ambient light,
excessive light may cause inaccurate measurements. In such cases,
cover the sensor with an opaque material.
cover the sensor with an opaque material.
If the sensor is wrapped too tightly or supplemental tape is applied,
venous pulsations may lead to inaccurate saturation measurements.
Excessive motion may compromise performance. In such cases, try to
keep the patient still, or change the sensor site to one with less
motion.
motion.
Intravascular dyes or externally applied coloring such as nail polish,
dye, or pigmented cream may lead to inaccurate measurements.
Do not pull the sensor cable to remove the sensor from the device.
In the event of damage to the sterile packaging, do NOT use. Make
sure to check whether the packaging and product is cracked or
damaged before use. If there is any damage.
damaged before use. If there is any damage.
Do not immerse in water or cleaning solutions. Do not resterilize.
For additional warnings, cautions or contraindications when using
sensors with Nellcor-compatible device, refer to each SpO
2
sensor
instruction manual.