Справочник Пользователя для Somfy Systems BRZ
GRABER
GRABER
11
Adding a New Remote as a Group Control
To add a group control to an existing shade, you
must first clear the current remote(s) from the motors
and remotes.
must first clear the current remote(s) from the motors
and remotes.
1. Press and hold the program button on the back
side of the old remotes until the LED turns from
flashing green to flashing amber, then release.
flashing green to flashing amber, then release.
2. At the headrail/motor end, press and hold the
program button until the LED turns from
flashing green to flashing amber. The shade will
jog once, then release.
flashing green to flashing amber. The shade will
jog once, then release.
3. The LED light bar will turn solid green and the
shade will jog, confirming they are now joined.
Include the new remote as the group (primary) control
1. Press and release the program button on the
back side of the new remote twice in rapid
succession (with one second between taps).
succession (with one second between taps).
2. The LED on the new remote will alternately flash
amber and green to identify inclusion mode.
3. Press and hold the program button on the
headrail/motor end, release when LED
flashes green.
flashes green.
4. The shade will jog and all LED’s will turn off.
5. The shade will now operate from the newly
5. The shade will now operate from the newly
added remote.
Repeat this process for each remote to be added to
this group.
this group.
Associate existing remotes as secondary control.
1. Press and release the program button on the
back side of the primary group remote twice
(with one second between taps).
(with one second between taps).
2. The LED on the primary remote will alternately
flash amber and green to identify inclusion mode.
3. On the existing remote, press and hold the
programming button until the LED begins to flash
green, then release the button.
green, then release the button.
4. Once the LEDs are off, on the existing remote,
press and release the program button until the
LED begins to alternately flash green.
LED begins to alternately flash green.
5. Press and HOLD the program button on the
headrail/motor end until the LED flashes green,
then release the button.
then release the button.
Repeat this process for each remote to be added to
this group.
this group.
If a group control was not selected t the time of purchase and is being added to an existing motorized shade, follow the
steps below.
steps below.
Note: Individual shade control will be maintained with the original two-button remote only after it is associ-
ated with the shade (see next page).