Справочник Пользователя для Sony Corporation DWTP01N

When the RF REMOTE function is off, REMOTE
cannot be selected.

When the receiver does not support encryption key
exchange through USB connection, select REMOTE.

When you select USB:
Connect the transmitter to the receiver using a USB
cable (not supplied) and the USB adapter cable
(supplied).

For details on receiver operations, refer to the
operating instructions supplied with the receiver.

When you select REMOTE:
The transmitter searches for a receiver that it has been
paired with. After the transmitter detects the receiver,
the transmitter exchanges the encryption key with
receiver and encrypted transmission begins.

Using password mode

(PASSWORD)

Set this mode when multiple transmitters are paired with
multiple receivers for encrypted transmission.
If both transmitters and receivers are set with the same
user-designated password, the audio signal can be
decoded. This mode is useful when multiple transmitters
and receivers are used as a single group, or when the audio
signal from one transmitter is received by multiple
receivers at the same time.

Hold down the SET button until the item to be set
flashes in the ENCRYPTION indication on the
transmitter.

Press the + or – button repeatedly to select
PASSWORD, and then press the SET button.

Input a password of up to eight characters on the
transmitter.

To enter a password, use the procedure described in
“Naming of transmitter (NAME)” on page 11.

Set the encrypted transmission function setting on the
receiver to PASSWORD.

Set the same password that was set on the transmitter.

For details on receiver operations, refer to the
operating instructions supplied with the receiver.

It is recommended that you change the password
periodically.

Note

USB cable (not supplied)

USB adapter cable
(supplied)

Note