Справочник Пользователя для Sony Corporation RM215
14
Setting the Receiving Channel
3
Hold down the SET button until the
item to be set flashes.
item to be set flashes.
4
Press the + or - button repeatedly to
select a frequency band.
select a frequency band.
5
Press the SET button to confirm the
selection.
selection.
6
Press the + or - button repeatedly until
the GP/CH screen is displayed.
the GP/CH screen is displayed.
7
Hold down the SET button until the
item to be set flashes.
item to be set flashes.
8
Press the + or - button repeatedly to
select a group.
select a group.
9
Press the SET button to confirm the
selection.
selection.
The channel indicator starts flashing.
10
Press the + or - button repeatedly to
select a channel.
11
Press the SET button to confirm the
selection.
When the wireless remote control
function is operating:
function is operating:
When you change the BAND/GP/CH
setting on the receiver, you can send the
BAND/GP/CH setting to the transmitter
that is paired with the receiver.
setting on the receiver, you can send the
BAND/GP/CH setting to the transmitter
that is paired with the receiver.
If the receiving channel (CH) configured on
the receiver is a channel for which use with
the wireless remote control function is
restricted on the transmitter side, the
UNMATCH screen appears.
In such cases, change the receiving channel
on the receiver. If you want to use the
restricted channel, set REMOTE to OFF in
the transmitter’s menu to release the
channel restriction, and manually configure
the transmitter’s channel.
the receiver is a channel for which use with
the wireless remote control function is
restricted on the transmitter side, the
UNMATCH screen appears.
In such cases, change the receiving channel
on the receiver. If you want to use the
restricted channel, set REMOTE to OFF in
the transmitter’s menu to release the
channel restriction, and manually configure
the transmitter’s channel.
About use of the same group
and channel by adjacent
systems
and channel by adjacent
systems
When the same group and channel are being
used by two or more systems that are within
sight of each other and are separated
without partitions or obstacles in wide open
place, each system should be at least 100
meters away from the others to avoid
interference.
used by two or more systems that are within
sight of each other and are separated
without partitions or obstacles in wide open
place, each system should be at least 100
meters away from the others to avoid
interference.
Using the Active Channel
Scan Function
Scan Function
This function scans for a Sony digital
wireless frequency from the frequency lists
within the GP (group) selected during the
GP/CH selection function.
wireless frequency from the frequency lists
within the GP (group) selected during the
GP/CH selection function.
Required condition for the detection:
• Sony digital wireless signal
• Above the RF squelch level of the
• Sony digital wireless signal
• Above the RF squelch level of the
receiver
• The setting of the encrypted transmission
function is correct.
1
Press the MENU SELECT button
repeatedly until the RX1/RX2 menu is
displayed.
repeatedly until the RX1/RX2 menu is
displayed.
2
Press the + or
–
button repeatedly until
the ACT CH SCAN indication is
displayed.
displayed.
3
Hold down the SET button until the
item to be set flashes.
item to be set flashes.
4
Press the + or
–
button repeatedly to
select YES.
Scanning starts. When a Sony digital
wireless frequency is detected,
scanning stops and the frequency is
displayed.
If you select NO, the scanning function
will be cancelled.
wireless frequency is detected,
scanning stops and the frequency is
displayed.
If you select NO, the scanning function
will be cancelled.
Note