Справочник Пользователя для Kenwood USA Corporation 383200

You can scan the transceiver channels to search for a signal.  

When the transceiver verifies a signal on a channel, it proceeds 

to check whether or not its QT/ DQT setting matches that 

which is set up on your transceiver (if you have set a channel 

with QT/ DQT).  If the QT/ DQT matches, the transceiver stops 

at the channel and opens the squelch so you can listen to the 

call.  If the QT/ DQT does not match, the call is ignored and 

scanning continues.
Before you can use the scan function, ensure that it is 

activated.  You can turn the scan function (the ability to perform 

scan) ON or OFF in Setting mode.

  With the transceiver power OFF, press and hold the MENU 

key while turning the transceiver power ON (for 1 second).

  Press the   or   key to select “SC”.

  Press the MENU key then press   or   to select “SC-oF” 

(scan function disabled) or “SC-on” (scan function enabled).

•  If you select “SC-oF”, you will no longer be able to perform 

scan by pressing and holding the   key {page 18}. 

  Press the MENU key to confirm the selection.

  Press the PTT, MON, or CAL key to exit Setting Mode.