Справочник Пользователя для Sharp Corporation HRO00095
364
e16_dv65_7e.fm
[364/374]
[364/374]
Data Management
Use the Ir communication function from running i-
appli.
Activating i-
appli from Ir communication is also possible.
For details on activating Ir communication from i-
appli nP. 292
During Ir communication, if a signal to activate i-
appli is received from
devices supporting Ir communication, software can be activated.
1
In the Custom menu, select [LifeKit]
/
[Receive Ir
data]
/
[Receive]
/
[Yes].
: The FOMA terminal waits to receive data. Software is activated when
signal to activate i-
appli is received from the sender’s FOMA
terminal.
Use the FOMA terminal’s Infrared port from i-
appli software to
operate equipment supporting the infrared remote control such
as TVs and VCRs.
as TVs and VCRs.
To use the infrared remote control function, download compatible i-
appli
software.
Start i-
appli software that supports Ir remote control functions, point the
FOMA terminal’s Ir port to the front of the remote control sensor on the TV,
VCR or other device to operate, and perform remote control operations.
VCR or other device to operate, and perform remote control operations.
Actual operational methods will differ with each i-
appli software
application.
Control devices from a distance of up to approximately 4 m (Distance will
vary depending on the device, the ambient brightness and other factors).
vary depending on the device, the ambient brightness and other factors).
Use iC communication to send and receive data to and from other
FOMA terminals which also support iC communication function.
FOMA terminals which also support iC communication function.
During iC communication, the FOMA terminal status is the same as
when outside the service area, such that making/receiving calls, i-mode,
and data communications are not possible.
when outside the service area, such that making/receiving calls, i-mode,
and data communications are not possible.
iC communication is not available while a call is in progress or the IC
card is locked.
card is locked.
Using Ir communication with i-
appli
Activating i-
appli from Ir communication
When i-
appli To is set to [No], i-appli is not activated from Ir
communication.
Cannot be activated as i-
appli stand-by.
Infrared remote control
Using infrared remote control function
Remote control operation
When in the Self mode, the Ir remote control function cannot be used.
Depending on the device, operation may not run properly.
Remote control operation may not run properly directly under
fluorescent lights, near other equipment using infrared signals, or in
areas of direct sunlight.
fluorescent lights, near other equipment using infrared signals, or in
areas of direct sunlight.
iC communication
15°
Approx. 4 m
15°
Infrared port
dv65_E.book 364 ページ ２００９年４月１０日 金曜日 午前９時６分