Справочник Пользователя для Motorola Solutions Inc. 89FT3797
FCC ID: AZ489FT3797
Batteries
CAUTION
Do not remove the plastic wrap from the battery pack. This may permanently damage the battery.
The Ni-Cd battery ships uncharged, it must be fully charged for 16 hours before use (first charge
only). It is recommended that only Motorola batteries and chargers are used with the radio.
only). It is recommended that only Motorola batteries and chargers are used with the radio.
The Ni-Cd rechargeable battery pack will provide approximately 8 hours of use on a 2 watt radio
and 10 hours on a 1 watt radio with normal use i.e. 5% sending messages, 5% receiving messages
and 90% in standby mode.
and 10 hours on a 1 watt radio with normal use i.e. 5% sending messages, 5% receiving messages
and 90% in standby mode.
To Install/Remove battery :
Note : Radio must be in OFF position before installing/removing battery.
1. Push back battery cover latches until you see the orange tabs.
2. Slide battery cover down and lift to remove.
3. To replace/install battery, insert the battery pack with arrows facing you and towards top of
2. Slide battery cover down and lift to remove.
3. To replace/install battery, insert the battery pack with arrows facing you and towards top of
radio..
4. Replace the battery cover and lock latches.
5. To remove battery: remove cover (steps 1 & 2), turn the radio over and tap the battery end of
5. To remove battery: remove cover (steps 1 & 2), turn the radio over and tap the battery end of
the radio against the palm of your hand. The battery will drop into your hand.
Charging the Ni-Cd battery Pack
Charging Adapter Instructions :
1. Turn the radio off.
2. Lift accessory cover and plug the Charger Adapter firmly into the small jack (lower hole).
3. Plug the Charger into an electric outlet.
2. Lift accessory cover and plug the Charger Adapter firmly into the small jack (lower hole).
3. Plug the Charger into an electric outlet.
The red light on the charger will glow continuously if charging properly.
4. Allow 10 hours for the battery to fully charge.
NOTE: For optimum battery life, the battery should not be left charging for prolonged periods
after reaching full charge. Charging the battery over the weekend is acceptable.
after reaching full charge. Charging the battery over the weekend is acceptable.
NOTE: Transmitting while radio is charging in the Wall Charger can cause the radio transmitter
or the charger to operate improperly. Do not transmit while radio is charging. If radio is on while
charging, at least twice as much time is required to charge the battery. Turn the radio off when
charging.
or the charger to operate improperly. Do not transmit while radio is charging. If radio is on while
charging, at least twice as much time is required to charge the battery. Turn the radio off when
charging.
10 Hour Desktop Charger Instructions :
1. Connect Desktop Charger and Charger Adapter.
2. Charge the battery while inside the radio by placing the radio in the Charger Tray with
2. Charge the battery while inside the radio by placing the radio in the Charger Tray with
radio facing towards you. You can also charge the battery by removing battery from radio
and placing it in Charger Tray with silver contacts facing down and arrow facing toward
the front.
and placing it in Charger Tray with silver contacts facing down and arrow facing toward
the front.