Справочник Пользователя для High-Flying Electronics Technology Co. Ltd HF-A11X
HF-A11x V3.1 User Manual
Shanghai High-Flying Electronics Technology Co., Ltd
www.hi-flying.com
42
MAXSK
Set/Query maxima TCP connection
EPHY
Open/Close ETH interface
RELD
Restore to factory default setting
Z Re-start
module
MID
Query module ID information
VER Query
module
software version information
H Help
Notes: HF-A11x module can works as AP or STA, user have to use different AT+ Instruction to
set WiFi parameters when module works as AP or STA mode.
4.2.2.1. AT+E
Function: Open/Close show back function;
Format:
Format:
AT+E<CR>
+ok<CR>< LF ><CR>< LF >
When HF-A11x module firstly switch from transparent transmission to configuration mode, show
back status is open, input “AT+E” to close show back function, input“AT+E” again to open show
back function.
4.2.2.2. AT+ENTM
Function: Set module into transparent transmition mode;
Format:
Format:
AT+ENTM<CR>
+ok<CR>< LF ><CR>< LF >
When operate this command, module switch from configuration mode to transparent transmission
mode.
mode.
4.2.2.3. AT+NETP
Function: Set/Query network protocol parameters;
Format:
Format:
Query
Operation
AT+NETP<CR>
+ok=<protocol,CS,port,IP><CR>< LF ><CR>< LF >
Set
Operation
AT+NETP=<protocol,CS,port,IP><CR>
+ok<CR>< LF ><CR>< LF >
Parameters:
protocol:
TCP
UDP
UDP
CS: Network mode:
SERVER
CLIENT
CLIENT
Port: protocol port ID: Decimal digit and less than 65535
IP: Server’s IP address when module set as client
IP: Server’s IP address when module set as client
After HF-A11x module boots up again, the setting will be effective.