Справочник Пользователя для Andrew Wireless Innovations Group M17P26
3. COMMISSIONING
3.1.
MECHANICAL INSTALLATION
3.1.1. General
Read the health and safety warnings in section 1.2 Health and Safety Warnings.
1. Do not install the unit in a way or at a place where the specifications
outlined in the Environmental and Safety Specifications leaflet of the
manufacturer are not met.
manufacturer are not met.
2. It is strongly recommended to install the unit vertically.
3. When mounting the Remote Unit, the connector flange (illustrated in
3. When mounting the Remote Unit, the connector flange (illustrated in
chapter 3.2.2 Connections) with the cables must point to the ground. A
maximum tilt angle of 25° to the horizontal position of the connector flange
must be kept in each mounting direction. For details, refer to chapter 5.4.3
Mechanical Specifications of ION-M17P/26EU. If a different installation of the
Remote Unit is required, please contact customer service for further
information.
maximum tilt angle of 25° to the horizontal position of the connector flange
must be kept in each mounting direction. For details, refer to chapter 5.4.3
Mechanical Specifications of ION-M17P/26EU. If a different installation of the
Remote Unit is required, please contact customer service for further
information.
4. It is recommended only to use the mounting hardware delivered by the
manufacturer. If different mounting hardware is used, the specifications for
stationary use of the Remote Unit must not be exceeded.
stationary use of the Remote Unit must not be exceeded.
Note:
Exceeding the specified load limits may cause the loss of warranty!
5. The unit is considerably heavy. Make sure that a suitable mounting surface
is used. Ensure there is adequate manpower to handle the weight of the
system.
system.
Page 14
Manual MF0133AUA.doc