Справочник Пользователя для Mitsubishi Electric Corp 485
31
Others
Reference page
Before Calling for Service
Symptom
Installation
No power supplied to VCR.
The VCR POWER is ON, but the unit
does not operate.
does not operate.
No picture displays on the MONITOR
screen.
screen.
The picture is not clear on the monitor.
• Has the power cord been disconnected from the AC outlet?
• Is the Lock indicator (
• Is the Lock indicator (
) illuminated?
Press the SEARCH button on the front panel for more than 10 seconds to
unlock the VCR.
• Is the Timer Recording indicator ( ) illuminated?
Press the TIMER REC button on the front panel to cancel the timer recording.
• Is the Lock indicator (
) illuminated?
Press the SEARCH button on the front panel for more than 10 seconds to
unlock the VCR.
• Safety devices are in operation.
Press the RESET button on the back panel using a pointed instrument, and
then turn the power on again.
• Is the monitor or the camera connected correctly?
Check the connection.
• Is the connecting cable properly connected, or is the cable defective?
Check the connection and also check for the snapping of a wire in the cable.
• Is the camera focused?
See the user’s manual for your camera and focus the camera correctly.
Function/operation
No operation when any tape operation
button is pressed.
button is pressed.
The present time is not correct even if
using the VCR everyday.
using the VCR everyday.
The power cord has been disconnected
for less than 31 days, but the present
time has been reset.
for less than 31 days, but the present
time has been reset.
Remedy
• Is the Lock indicator (
) illuminated?
Press the SEARCH button on the front panel for more than 10 seconds to
unlock the VCR.
• Is a cassette inserted?
Make sure the power cord is connected to the AC outlet for approximately 40 or
more hours per week when using it everyday.
Make sure the power cord is connected to the AC outlet for approximately 40 or
more hours per week when using it everyday.
• The reserved contents may be erased even within 31 days depending on the
charging time of the power failure compensation circuit.
Set the present time setting again.
Recording
Recording does not work by pressing
the REC button.
the REC button.
Recording cannot be stopped by
pressing the STOP button.
pressing the STOP button.
Repeat recording does not work.
• Is the Lock indicator (
) illuminated?
Press the SEARCH button on the front panel for more than 10 seconds to
unlock the VCR.
• Has the cassette’s erasure prevention tab been broken off?
Load the cassette with its erasure prevention tab intact.
• Has the tape run out?
Rewind the tape or load a new tape.
• Is the Lock indicator (
) illuminated?
Press the SEARCH button on the front panel for more than 10 seconds to
unlock the VCR.
• Is the VCR in timer recording mode (Timer recording indicator ( ) is illuminating)?
Press the TIMER REC button once.
• Is the Repeat indicator (
) illuminated?
Set TAPE END in the FIRST TIME SET UP menu to REPEAT or
ALARM•PROT.
When TAPE END in the FIRST TIME SET UP menu is set to ALARM•PROT,
repeat recording does not work using a tape with an alarm recording.
When a tape reaches its end during the emergency recording (recording
started while the VCR is stopped or the VCR power is off), the VCR rewinds
the tape and stops (recording does not start again) even though TAPE END in
the FIRST TIME SET UP menu is set to REPEAT.
the tape and stops (recording does not start again) even though TAPE END in
the FIRST TIME SET UP menu is set to REPEAT.
When you find any problem with this VCR, first check the following. If you still cannot solve the problem, stop using the VCR, unplug
it from the AC outlet, and contact your dealer.
it from the AC outlet, and contact your dealer.