Справочник Пользователя для Innovative Technology Electronics LLC VJB-105
TROUBLESHOOTING GUIDE
THE OPERATING INSTRUCTIONS REFLECT THE CURRENT TECHNICAL
SPECIFICATION OF THIS PRODUCT AT TIME OF PRINT.
WE RESERVE THE RIGHT TO CHANGE SPECIFICATIONS FOR TECHNICAL REASONS
WITHOUT PRIOR NOTICE.
SPECIFICATION OF THIS PRODUCT AT TIME OF PRINT.
WE RESERVE THE RIGHT TO CHANGE SPECIFICATIONS FOR TECHNICAL REASONS
WITHOUT PRIOR NOTICE.
12
OPERATING INSTRUCTIONS
BYL-12: JUKEBOX-PHONOGRAPH
The following checks will assist in the correction of most problems which you
may encounter with your set. Before going through the check list below, first
check the following points.
The power cord must be connected firmly.
Should any problem persist after you have made these checks consult
your nearest dealer
Symptom
Possible Causes (and Remedies)
RADIO RECEPTION
No radio
reception
The MODE selector has not been set to the correct position.
Adjust the VOLUME knob.
Rotate the TUNING knob to find a radio station.
Switch the AUX IN jack to “OFF”
Adjust the VOLUME knob.
Rotate the TUNING knob to find a radio station.
Switch the AUX IN jack to “OFF”
CD PLAYER OPERATION
Disc does not play
Or sound skips
Reload the disc with the label side up
Clean the disc.
Sound skips
Change the installation location.
Press the Reset button.
Unit is not
working.
Press the STOP button and then program the tracks.
GENERAL
Programmed disc
play will not
function
The AC power cord is not connected to an AC wall outlet.
Check that the power cord is connected firmly.
Push the power button from the “OFF” position to the “ON”
position.
Check that the power cord is connected firmly.
Push the power button from the “OFF” position to the “ON”
position.
No sound output.
Turn VOLUME knob clockwise. Press the Reset button.
Switch the AUX IN jack to “OFF” and remove the RCA cord.
Switch the external speaker jack on the back cover.
Switch the AUX IN jack to “OFF” and remove the RCA cord.
Switch the external speaker jack on the back cover.
Severe hum or
noise.
noise.
The TV or VCR is too close to the stereo system.
Separate from the TV or VCR.
Display garbled,
non-functional.
Turn Off the power to restart.