Справочник Пользователя для Iotek Systems LLC HXC900
HXC Client Module User Guide
Version 1.09
© 2017 All rights reserved. Iotek Systems, LLC
Page 47 of 59
AT+RX=0
// Turn off the reception.
>>>
OK
The received data will be printed using UART.
>>>
rxDone
>>>
rxdata:<Hex Bytes>
Users can receive AT_BUSY_ERROR if the command is used during a LoRa packet
transmission (Join, Packet send or Continuous Tx).
transmission (Join, Packet send or Continuous Tx).
AT+RX=1
>>>
AT_BUSY_ERROR
Users can receive AT_INVALID_MODE if the +MODE is not LORA.
AT+RX=1
>>>
AT_INVALID_MODE
8.7.5.5 AT+TXCW: Continuous Transmit
This command allows the user to set the radio to output the fundamental frequency
(unmodulated). It is mainly used for ETSI and FCC certification. It will use AT+RFCFG
(unmodulated). It is mainly used for ETSI and FCC certification. It will use AT+RFCFG
command’s <Freq>,<SF>,<BW>,<PWR> parameters. This command doesn’t depend
on AT+MODE configuration.
on AT+MODE configuration.
Format:
AT+TXCW=<timeout in seconds>
AT+TXCW?
>>>
Turn ON Continuous Tx
>>>
OK
AT+TXCW=60
>>>
OK
Users can receive AT_BUSY_ERROR if the command is used during a LoRa packet
transmission (Join, Packet sending or Continuous Tx).
AT+TXCW=10
>>>
AT_BUSY_ERROR
8.7.6 Diagnostic Commands
This section provides a set of commands to provide diagnostic information on the RF
signal quality and battery level.
8.7.6.1 AT+BAT: Set Battery Level
This command allows users to set the battery level of the client. If the network server
requests for device status (DevStatusReq) this battery level, along with the last received
packet’s SNR, will be incorporated in the ‘DevStatusAns’.
packet’s SNR, will be incorporated in the ‘DevStatusAns’.
Battery
Description
0
The end-device is connected