Справочник Пользователя для Iotek Systems LLC HXC900
HXC Client Module User Guide
Version 1.09
© 2017 All rights reserved. Iotek Systems, LLC
Page 58 of 59
13.2 Industry Canada (IC)
13.2.1 Section 8.4 of RSS-GEN
This Device complies with Industry Canada License-exempt RSS standard(s). Operation is
subject to the following two conditions: 1) this device may not cause interference, and 2)
this device must accept any interference, including interference that may cause undesired
operation of the device.
this device must accept any interference, including interference that may cause undesired
operation of the device.
Cet appareil est conforme aux normes RSS exemptes de licence d'Industrie Canada. Son
fonctionnement est soumis aux deux conditions suivantes: 1) cet appareil ne doit pas
fonctionnement est soumis aux deux conditions suivantes: 1) cet appareil ne doit pas
provoquer d'interférences et 2) cet appareil doit accepter toute interférence, y compris
les interférences pouvant entraîner un fonctionnement indésirable de l'appareil.
les interférences pouvant entraîner un fonctionnement indésirable de l'appareil.
13.2.2 Section 8.3 of RSS-GEN
Under Industry Canada regulations, this radio transmitter may only operate using an
antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry
antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry
Canada. To reduce potential radio interference to other users, the antenna type and its
gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not
more than that necessary for successful communication.
gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not
more than that necessary for successful communication.
En vertu des règlements d'Industrie Canada, cet émetteur radio ne peut fonctionner
qu'avec une antenne de type et un gain maximum (ou moindre) approuvé pour
l'émetteur par Industrie Canada. Pour réduire les interférences radio potentielles avec
d'autres utilisateurs, le type d'antenne et son gain doivent être choisis de manière à ce
l'émetteur par Industrie Canada. Pour réduire les interférences radio potentielles avec
d'autres utilisateurs, le type d'antenne et son gain doivent être choisis de manière à ce
que la puissance isotrope rayonnée équivalente (e.i.r.p.) ne soit pas supérieure à celle
nécessaire pour une communication réussie.
nécessaire pour une communication réussie.
13.3 OEM Responsibilities to comply with FCC and Industry Canada Regulations
The HXC Client Module (HXC900) has been certified for integration into products only by
OEM integrators under the following conditions:
• The antenna(s) must be installed such that a minimum separation distance of
20cm is maintained between the radiator (antenna) and all persons at all times.
• The transmitter module must not be co-located or operating in conjunction with
any other antenna or transmitter.
As long as the two conditions above are met, further transmitter testing will not be
required. However, the OEM integrator is still responsible for testing their end-product
for any additional compliance requirements required with this module installed (for
example, digital device emissions, PC peripheral requirements, etc.).
for any additional compliance requirements required with this module installed (for
example, digital device emissions, PC peripheral requirements, etc.).
IMPORTANT NOTE: In the event that these conditions cannot be met (for certain
configurations or co-location with another transmitter), then the FCC and Industry
Canada authorizations are no longer considered valid and the FCC ID and IC Certification
Number cannot be used on the final product. In these circumstances, the OEM integrator
Number cannot be used on the final product. In these circumstances, the OEM integrator