Справочник Пользователя для Shenzhen City Yigulu Sci-Tech Private Limited Company V4

1" [25mm]dia.
side hole

Door’s edge for
1-¾”(44.5mm)
thickness

Optional hole, Ø10mm

for 2-3/4" [70mm] backset
1-3/4"[44.5mm] thickness
1:1 drilling template

Fold along this line

and align with the

door’s corner edge

2-3/4"[70mm]

2-1/8" [54mm]

hole

25.5

1. Prior to assembly,

Status Verification

2. Parts & Components Layout

3. General Assembly

4. Set-Up

5. Insert the bolt

6. Touch-screen installation

7. Back-side assembly

8. Sensor

9. Rubber Pad

10. Access handle

11. Attach the touchscreen’s wires

to the right port as shown below

12. Remove the battery cover and

set the toggle base as mentioned

in Page 2. B)

13. Rear Lock

14. Sensor assembled onto frame

A) If you have already mounted a mechanical deadbolt. Please remove

the existing deadbolts from the door and replace them with our

smart deadbolt. Installation is drilling-free.

B) Verify the door’s opening direction: if it is fastened in the left, push

the toggle to the left. And if it fastened in the right, push it to the

right.

C)Kindly confirm the door’s interior thickness.

(Must be between 35mm to 55mm)

Door thickness shall be

“1-3/8” to “2-5/32”

Different thickness might

not be suitable

4mm depth for the plate cover

Leave an allowance of

4 inches between the

handle and the drilled hole.

Adjust the length of the bolt if

it's required.

Optional

(Assemble through this bolt if an

additional hole was drilled)

Verify it fits through this hole in the correct position

NOTE: if the Pin length is longer than the door

thickness, you can cut 1 or more slot

away to make the mounting properly.

Side the safety block to remove

the battery’s cover

Push the toggle to the L/R position according to the door placement.

If the door fastened in the Right, push it to the R, if door fastened in

the Left, push it to the L.

When assembled, please turn the wheel to test if it in

the right position.

If you could NOT turn the wheel, please pull the access

device out, turn 90° and re-insert. Once functioning

properly and bolt is moving, it is in the correct position.

*NOTE:

The door will lock itself once sensor is activated.

Do NOT insert the battery while assembling.

Toggle

L or R