Справочник Пользователя для Samsung Electronics Co Ltd DRMODEMZ1
DR-Ready modem
User manual
imagine
the possibilities
Thank you for purchasing this
Samsung product. To receive a
more complete service, please
register your product at
www.samsung.com/register
WARNING
The DR-Ready modem only works for the following Samsung models.
Since the modem can only be installed in the following models, please
confirm that your product is one of the following models.
• Refrigerator: RF4289HARS, RSG309AARS
• Washer/Dryer: WF461ASP/XAA / DV431ASP/XAA
• Dishwasher: DMT-611
• Refrigerator: RF4289HARS, RSG309AARS
• Washer/Dryer: WF461ASP/XAA / DV431ASP/XAA
• Dishwasher: DMT-611
WheN INstAllING youR DR-ReADy moDem
Do not install the modem on an unstable surface.
• If the product falls, it may result in injury or damage to property.
Do not install the modem near a heater, volatile substance (oil, etc.) or
• If the product falls, it may result in injury or damage to property.
Do not install the modem near a heater, volatile substance (oil, etc.) or
inflammable material.
• This may result in electric shock or fire.
Do not install the modem in a humid or dusty location, a location
• This may result in electric shock or fire.
Do not install the modem in a humid or dusty location, a location
exposed to direct sunlight water (rain drops, etc.), or a location where
gas may leak.
• This may result in electric shock or fire.
To reinstall the modem, contact the service center.
• This may result in electric shock or fire.
To reinstall the modem, contact the service center.
WheN usING youR DR-ReADy moDem
Do not connect the DR-Ready modem to an incompatible product.
• This may result in a problem or product malfunction.
If the modem generates a strange sound, smell or smoke, remove the
• This may result in a problem or product malfunction.
If the modem generates a strange sound, smell or smoke, remove the
modem from the product immediately, disconnect the LAN cable and
contact the service center.
• Failing to do so may result in electric shock or fire.
• Failing to do so may result in electric shock or fire.
If the modem becomes flooded, immediately remove the modem
from the product, disconnect the LAN cable and contact the service
center.
• This may result in electric shock or fire.
If water or a foreign object enters the modem, immediately remove
• This may result in electric shock or fire.
If water or a foreign object enters the modem, immediately remove
the modem from the product (refrigerator, washer or dishwasher),
disconnect the LAN cable and contact the service center.
• Failing to do so may result in electric shock or fire.
Do not touch the modem or LAN cable with wet hands.
• This may result in electric shock, fire or injury.
Do not intentionally apply excessive force to the modem.
• This may result in a problem with or damage to the product.
Do not disassemble, repair or modify the modem yourself.
• This may result in electric shock, fire, damage to the product or
• Failing to do so may result in electric shock or fire.
Do not touch the modem or LAN cable with wet hands.
• This may result in electric shock, fire or injury.
Do not intentionally apply excessive force to the modem.
• This may result in a problem with or damage to the product.
Do not disassemble, repair or modify the modem yourself.
• This may result in electric shock, fire, damage to the product or
injury.
Do not step on the modem or place an object (laundry, lighted candle,
lighted cigarette, dish, chemical, metal object, etc.) on the modem.
• This may result in a problem with or damage to the product.
Do not use a sharp object with the modem.
• This may result in a problem with or damage to the product.
• This may result in a problem with or damage to the product.
Do not use a sharp object with the modem.
• This may result in a problem with or damage to the product.
CeRtIfICAtIoN
• FCC: A3L-DRMODEMZ1
• ZigBee: ZIG11004ZSE26067-24
• ZigBee: ZIG11004ZSE26067-24
CheCkING the pARts
Power
Front panel
Rear panel
Packaging contents
DR-Ready modem
(1)
1.5 m direct LAN
cable (1)
User manual (1)
Since there is a magnet at the bottom of the modem, you can
easily fix it to the metal part of the product.
INstAllING youR DR-ReADy moDem IN youR
RefRIGeRAtoR
DR-port
1. Enter the MAC and PIN numbers on the label attached to the
bottom of the modem into your DRC. (For the procedures to enter
the MAC and PIN numbers, refer to the DRC user manual.)
2. Open the rubber cover of the DR-port at the back of your
refrigerator and connect the LAN cable supplied with the modem
to the DR-port.
For the exact position of the DR-port, refer to the user
manual for the corresponding refrigerator.
3. Close the cover.
4. Connect the other end of the direct LAN cable to the Host I/F port
4. Connect the other end of the direct LAN cable to the Host I/F port
of the modem.
5. Check the connection. (Refer to the “Confirming the connection”
section.)
6. Attach the modem to the top or side of the refrigerator.
INstAllING youR DR-ReADy moDem IN youR
WAsheR oR DRyeR
DR-port
1. Enter the MAC and PIN numbers on the label attached to the
bottom of the modem into your DRC. (For the procedures to enter
the MAC and PIN numbers, refer to the DRC user manual.)
2. Open the rubber cover of the DR-port at the back of your washer
or dryer and connect the LAN cable supplied with the modem to
the DR-port.
For the exact position of the DR-port, refer to the user
manual for the corresponding washer or dryer.
3. Close the cover.
4. Connect the other end of the direct LAN cable to the Host I/F port
4. Connect the other end of the direct LAN cable to the Host I/F port
of the modem.
5. Check the connection. (Refer to the “Confirming the connection”
section.)
6. Attach the modem to the top or side of the washer or dryer.
INstAllING youR DR-ReADy moDem IN youR
DIshWAsheR
DR-port
kickplate
1. Enter the MAC and PIN numbers on the label attached to the
bottom of the modem into your DRC. (For the procedures to enter
the MAC and PIN numbers, refer to the DRC user manual.)
2. Remove the kickplate at the bottom of your dishwasher.
3. Open the rubber cover of the DR-port at the bottom of your
3. Open the rubber cover of the DR-port at the bottom of your
dishwasher and connect the LAN cable supplied with the modem
to the DR-port.
For the exact position of the DR-port, refer to the user
manual for the corresponding dishwasher.
4. Close the cover.
5. Connect the other end of the direct LAN cable to the Host I/F port
5. Connect the other end of the direct LAN cable to the Host I/F port
of the modem.
6. Check the connection. (Refer to the “Confirming the connection”
section.)
7. Attach the modem to the bottom of the dishwasher and install the
kickplate.
Safety information
Setting up your DR-Ready modem
QUESTIONS OR COMMENTS?
CouNtRy
CAll
oR VIsIt us oNlINe At
U.S
800-SAMSUNG
(800-726-7864)
www.samsung.com
CANADA
800-SAMSUNG
(800-726-7864)
www.samsung.com/ca
Code No.: DC68-00000A_EN
feDeRAl CommuNICAtIoN CommIssIoN INteRfeReNCe
stAtemeNt
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
ImpoRtANt Note:
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
ImpoRtANt Note:
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20 cm between the radiator & your body.
This transmitter must not be co-located or operating in conjunction with any other
This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
DR-Ready_Modem_EN.indd 1
2011-05-27 �� 5:15:59