Справочник Пользователя для Whirlpool Corporation XPSG

Скачать
Страница из 3
CONNECTED APPLIANCE INFORMATION 
 
 
Federal Communications Commission (FCC) Compliance Notice  
 
This equipment has been tested and found to comply with the limits for a Class B digital device, 
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection 
against harmful interference in a residential installation. This equipment generates uses and can 
radiate radio frequency energy and, if not installed and used in accordance with the instructions, 
may cause harmful interference to radio communications. However, there is no guarantee that 
interference will not occur in a particular installation. If this equipment does cause harmful 
interference to radio or television reception, which can be determined by turning the equipment 
off and on, the user is encouraged to try to correct the interference by one of the following 
measures: 
- Reorient or relocate the receiving antenna. 
- Increase the separation between the equipment and receiver. 
- Connect the equipment into an outlet on a circuit different from that to which the receiver is 
connected. 
- Consult the dealer or an experienced radio/TV technician for help. 
 
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two 
conditions: 
1. This device may not cause harmful interference, and 
2. This device must accept any interference received, including interference that may cause 
undesired operation. 
 
Changes or modifications not expressly approved by the party responsible for compliance could 
void the user‟s authority to operate the equipment. 
 
RF Exposure Information 
To comply with FCC/IC RF exposure requirements for mobile transmitting devices, this 
transmitter should only be used or installed at locations where there is at least 20cm separation 
distance between the antenna and all persons. 
 
To comply with FCC/IC RF exposure limits for general population/uncontrolled exposure, the 
antenna(s) used for this transmitter must be installed to provide a separation distance of at least 
20 cm from all persons and must not be co-located or operating in conjunction with any other 
antenna or transmitter