Справочник Пользователя для RadioShack Corporation 400268T
S
e
tu
p
2
Attach rubber feet to speakers
Remove the backing on the bottom of the rubber feet and
attach them to the four corners on the bottom of each speaker.
3
Po�er the s�ste�
Po�er the s�ste�
Connect the supplied AC power adapters into the DC 12V jacks on the transmitter
and speakers, then plug the adapters into standard AC outlets.
You also can use 16 (8 for each speaker) D size
batteries (not supplied) to power the speakers.
To install the batteries:
To install the batteries:
1.
Remove the battery cover.
.
Insert 8 batteries for each speaker with
correct polarities.
.
Replace the cover when finished.
w
Caution:
You must use a Class 2 power source that supplies 12 volts DC and delivers at
least 250mA or 1250mA. Its center tip must be set to positive and its plug must
fit the transmitter’s DC 12V jack. The supplied adapter meets these specifications.
Using an adapter that does not meet these specifications will damage the
transmitter or the adapter.
Always connect the AC adapter to the transmitter before you connect it to AC
Always connect the AC adapter to the transmitter before you connect it to AC
power. When you finish, disconnect the adapter from AC power before you
disconnect it from the transmitter.
Speakers
12V, 1250mA
AC Adapter
Transmitter 12V, 250mA
AC Adapter
n
Note: Use the adapter labeled “12V 250 mA” for the transmitter, and the one
marked “12V, 1250 mA” for the speakers.