Справочник Пользователя для Motorola Solutions Inc. 99FT4096
English
English
8
Post-Installation Checklist
Applying Power
After the SLR 5000 Series Repeater has been mechanically installed
and all electrical connections have been made, power may now be
applied and the repeater checked for proper operation.
and all electrical connections have been made, power may now be
applied and the repeater checked for proper operation.
Front Panel LEDs
After turning on the repeater power, the seven LEDs on the repeater
front panel:
1. Light for approximately one second to indicate that they are
front panel:
1. Light for approximately one second to indicate that they are
functional, then
2. Go off for one second.
3. Indicate the operational status of the repeater.
Verifying Proper Operation
Operation of the repeater can be verified by:
• Observing the state of the seven LEDs located on the front panel,
• Observing the state of the seven LEDs located on the front panel,
and
• Exercising radio operation.
Table 1: Connector Type and Primary Function
NO
Connector
Function(s)
C14 (IEC
60320)
60320)
AC Power Inlet and Repeater
Power Switch
Power Switch
Molex 42818 –
0212
0212
DC Power Inlet and DC Charger
Outlet
Outlet
Option
Dependent
Dependent
Future Option 1
Option
Dependent
Dependent
Future Option 2
Type A Socket
USB
RJ-45 – Jack
Ethernet 1
RJ-45 – Jack
Ethernet 2
DB25 –
Female
Female
Rx Audio, Tx Audio, PTT, COR,
Accessory Power, 1 PPS, and
GPIO
Accessory Power, 1 PPS, and
GPIO
BNC – Female
Receiver RF
BNC – Female
Frequency Reference Input
T30 TORX
Screw
Screw
Bonding ground connection
N-Type –
Female
Female
Transmitter RF
1
2
3
4
5
6
7
8
9
10
11
12
Some repeater components can become extremely
hot during operation. Turn off all power to the
repeater and wait until sufficiently cool before
touching the repeater.
hot during operation. Turn off all power to the
repeater and wait until sufficiently cool before
touching the repeater.
SLR_5000_NAG.book Page 8 Monday, March 2, 2015 10:19 AM