Справочник Пользователя для Panasonic Corporation of North America 9TGCF-521

22

Follow the instructions below when an error message or code appears. If the problem persists or if the error code/mes-
sage is not shown here, contact Panasonic Technical Support (

page 36).

A

Restart the computer.

B

Press F2 several times while [Panasonic] boot screen is displayed.

Disconnect external keyboard or mouse.

An error has occurred in the memory of Setup Utility settings. This occurs when the memory 
content is changed by an unexpected program operation, etc. 

Start the Setup Utility and return the settings to the default values, and then change the 
settings as necessary.
If the problem persists, the internal clock battery may need to be replaced. Contact 
Panasonic Technical Support (

page 36).

The date and time settings are not correct.

Start the Setup Utility and set the correct date and time.
If the problem persists, the internal clock battery may need to be replaced. Contact 
Panasonic Technical Support (

page 36).

Startup has failed repeatedly, so the Setup Utility settings have been returned to the default 
values to startup the computer.

Start the Setup Utility and return the settings to the default values, and then change the 
settings as necessary.

Write down the error details and press F2 to start the Setup Utility. Change the settings if 
necessary.

The operating system is not installed in the floppy disk or the hard disk that you are going to 
boot from.

If using a floppy disk, change the disk to the one you can use for boot.
If using the hard disk, check if the hard disk is recognized in [Information] menu of the 
Setup Utility. If the hard disk is recognized, perform the reinstallation (

page 20). If not, 

contact Panasonic Technical Support (

page 36).

If a device is connected to the USB port, disconnect the device, or set [USB Port] or 
[Legacy USB Support] to [Disable] in [Advanced] menu of the Setup Utility.
If a device is connected to the ExpressCard slot, disconnect the device, or set [Express-
Card slot] to [Disable] in the [Advanced] menu of the Setup Utility.

When the RAM module is not inserted correctly or the RAM module is not conforming to the 
computer’s specifications, so a beep will sound and the “RAM Module Failed” message will 
be displayed when you turn the power on. 

Press the power switch for four seconds or longer to turn off the computer, confirm that 
the RAM module conforms to the specifications, and reinsert it.