Справочник Пользователя для ICOM 269800

66

12

OTHER FUNCTIONS

D

D Weather alert function

NOAA broadcast stations transmit weather alert tones before
important weather announcements. When the weather alert
function is turned ON, the selected weather channel is moni-
tored each 5 sec. for the announcement. When the alert sig-
nal is detected, the “AL.T” and the WX channel are displayed
alternately and sounds a beep tone until the transceiver is op-
erated. The previously selected (used) weather channel is
checked periodically during standby or while scanning.

q Select the desired weather channel.
w Turn the weather alert function ON in set mode.

➥ Push [SET

] to enter set mode.

➥ Push  [SET

] or  [S.MW

] to select the

weather alert item, then rotate [DIAL] to set ON.

➥ Push [TONE

] to exit set mode.

e Sets the desired stand-by condition.

• Selects VFO, memory or call channel.
• Scan or priority watch operation can also be selected.

r When the alert is detected, a beep sounds and the follow-

ing indication will be displayed.

t Turn the weather alert function OFF in set mode.

Shows above indications alternately.

☞ NOTE: While receiving a signal (on a frequency other than

the weather alert ON frequency), the receiving signal or
audio will be interrupted momentarily every 5 sec. 

(approx.)

in case the alert function is turned ON. This symptom is
caused by the WX alert function. To cancel these symp-
toms, set the weather alert item OFF in set mode.