Справочник Пользователя для ICOM 283300

39

10

PAGER/CODE SQUELCH

This display appears when you are called with your ID code
and the calling station’s ID code is 123.

This display appears when you are called with the group
code, 888, and 888 has been programmed into code channel
C6.

When the transceiver receives an incomplete signal, “E” and
previously received code appear.

■

Code squelch provides communications with quiet standby
since you will only receive calls from stations which know
your ID or group code. Each push of 

sends a 3-digit

code in order to open the receiving station’s code squelch
prior to voice transmission.

q Set the operating frequency.

• Set the AF and squelch to the desired level as in normal opera-

tion.

w Push 

, then push 

.

• Rotate 

to select “dtm.CS,” if “dtm.PG” or “dtm.OF” ap-

pears.

e Select the desired transmit code channel:

➥ Push 

for 1 sec. to enter code selection condi-

tion.

➥ Rotate 

to select the desired code channel.

➥ Push 

✱

to exit 

CODE SET MODE

and return to

previous condition.

• 100 MHz digit shows “C.” 

r Operate the transceiver in the normal way (push 

to

transmit; release 

to receive).

t To cancel the code squelch, push 

and 

,

then rotate 

to select “dtm.OF.”

• 100 MHz digit shows “1” when the function is cancelled.

Previously received code.

Code channel

“CP” and “    ” blink.

To use these functions in channel indication, the pager/code
squelch setting must be programmed with other memory con-
tents before selecting channel number indication.