Справочник Пользователя для ICOM 288800

FREQUENCY AND CHANNEL SETTING

■ Setting a tuning step

The tuning step can be selected for each frequency band.
The following tuning steps are available for the IC-91A/91AD.
• 5.0 kHz*

• 6.25 kHz* • 8.33 kHz

†

• 9.0 kHz

‡

• 10.0 kHz

• 12.5 kHz

• 15.0 kHz

• 20.0 kHz

• 25.0 kHz

• 30.0 kHz

• 50.0 kHz

• 100.0 kHz • 125.0 kHz • 200.0 kHz

* Appears for below the 600 MHz bands only.

†

Appears for the VHF air band only.

‡

Appears for the AM broadcast band only.

D Tuning step selection

q Push [VFO/MHz] to select VFO mode, if necessary.
w Push [BAND] to select the desired frequency band.

• Or, while pushing and holding [BAND], rotate [DIAL] to select

the desired frequency band.

e Push and hold [8/TS] for 1 sec. to enter tuning step set mode.
r Rotate [DIAL] to select the desired tuning step.
t Push [8/TS] (or [VFO/MHz]) to return to VFO mode.

■ Setting a frequency

D Using the dial

q Push [VFO/MHz] to select VFO mode, if necessary.
w Select the desired frequency band with [BAND].

• Or, while pushing and holding [BAND], rotate [DIAL] to select

the desired frequency band.

e Rotate [DIAL] to select the desired frequency.

• The frequency changes according to the preset tuning steps.

See the left section for setting the tuning step.

• Push and hold [VFO/MHz] for 1 sec. then rotate [DIAL] to

change the frequency in 1 MHz steps, or push and hold for 1 sec.
again then rotate [DIAL] to change the frequency in 10 MHz
steps. (Each pushing and holding for 1 sec. toggles 1 MHz or
10 MHz tuning steps.)

PRIO

PRIO WX

WX EMR

EMR

DTCS

146 010

+DUP

PRIO

PRIO WX

WX EMR

EMR

DTCS

146 010

+DUP

[DIAL]

[DIAL] changes the fre-
quency according to the se-
lected tuning step.

After pushing and holding
[VFO/MHz] for 1 sec., [DIAL]
changes the frequency in 1
MHz/10 MHz steps.

PRIO

PRIO WX

WX EMR

EMR

DTCS

146 010

+DUP

SET

TS:5.0kHz

000

SKIP

[DIAL]

5 kHz tuning step