Справочник Пользователя для ICOM 288800
66
8
MEMORY/CALL CHANNELS
■ Memory channel programming
q Push [VFO/MHz] to select VFO mode.
w Set the desired frequency:
w Set the desired frequency:
➥ Select the desired band with [BAND].
➥ Set the desired frequency with [DIAL].
➥ Or set the desired frequency with keypad directly.
In this case, the band and frequency settings with
[BAND] and [DIAL] as above are not required.
[BAND] and [DIAL] as above are not required.
➥ Set other data (e.g. offset frequency, duplex direction,
tone squelch, etc.), if desired.
e Push and hold [MR/S.MW] for 1 sec. to enter select mem-
ory write mode.
• 1 short and 1 long beep sound.
• “
• “
µµ ” indicator blinks.
r Rotate [DIAL] to select the desired channel.
• Call channels (C0, C1), VFO (VFO) and scan edge channels
(0A/0B to 24A/24B), as well as regular memory channels, can
be programmed in this way.
be programmed in this way.
t Push and hold [MR/S.MW] for 1 sec. to program.
• 3 beeps sound.
• Memory channel number automatically increases when contin-
• Memory channel number automatically increases when contin-
uing to push and holding [MR/S.MW] for 3 sec. after program-
ming.
ming.
[EXAMPLE]: Programming 145.870 MHz into memory chan-
nel 11 (blank channel).
[DIAL]
146 010
BANK
BANK :----
:----
MNAME:
MNAME:
SKIP
SKIP
SKIP :OFF
:OFF
FM
FM
r
µ
000
BANK
BANK :----
:----
MNAME:
MNAME:
SKIP
SKIP
SKIP :OFF
:OFF
r
µ
011
A
FM
FM
145 870
PSKIP
PSKIP
A
FM
FM
145 870
PSKIP
PSKIP
A
µ
FM
FM
145 870
PSKIP
PSKIP
011
VFO mode
Enter select memory
write mode.
write mode.
Rotate [DIAL] to select
channel 11.
channel 11.
Push
for 1 sec.
Channel 11
Push and hold
for 1 sec. to program.
Return to the VFO mode