Справочник Пользователя для ICOM 297400

10

3

MEMORY OPERATION

■

To program the memory channels, follow the steps below.

q

  Rotate 

[DIAL] and [O-DIAL] to set a desired frequency 

for the standby frequency.

w

  Push 

[RCL] to enter the memory mode.

 • The channel number appears.
 • The memory channel name also appears if it has been entered.

e 

 Rotate 

[O-DIAL] to select a desired memory channel 

type.

 • Select regular memory channel or group memory channel.

r

  Push 

[MEM], and then rotate [O-DIAL] to select the “RE-

PLACE” menu.

 • The memory channel number blinks.

t

  Rotate 

[DIAL] to select a memory channel to be pro-

grammed.

y

  Push 

[MEM], to program the frequency into the channel.

 • “WRITE COMPLETED” appears on the display when the regu-

lar memory channel is programmed.

u

 Push [RCL] to exit the memory mode.

■

The transceiver has 10 channels in regular memory and 200 
channels in the group memory. There are 10 channels in 
each of 20 groups (GRP01–GRP20).

q 

Push 

[RCL] to enter the memory mode.

 • The channel number appears.
 • The memory channel name also appears if it has been entered.

w 

Rotate 

[O-DIAL] to select the memory channel type.

 • Select from regular memory channel or group memory channel.

e 

 Rotate 

[DIAL] to select a desired memory channel 

number.

   

Transferring the memory channel to the active fre-
quency is necessary if you want to operate on the 
memory channel frequency.

   

Refer to “Transferring memory contents” (p. 12) for 
details.

r  

Push 

[RCL] to change to standby frequency to the se-

lected memory channel frequency and exit the memory 
mode.

CH01

127.00

5

122.00

RX

MEMORY

 Hold down 

[RCL] for 2 seconds to exit the mem-

ory mode without changing the previously set standby fre-
quency.