Справочник Пользователя для ICOM 307701
7
2
BASIC OPERATION
n
Turning power ON
When you use the transceiver for the first time, or after
the transceiver has sat unused for a long time, make sure
to check the date and time indication after turning the
power ON. If the time and date are not correct, reset
them. (p.10)
the transceiver has sat unused for a long time, make sure
to check the date and time indication after turning the
power ON. If the time and date are not correct, reset
them. (p.10)
q
Push [
] to turn the power ON.
w
If the transceiver is programmed for a start up password,
input the digit codes as directed by your dealer.
• 10-keypad* can be used for password input.
*10-key type only:
• The keys as below can be used for password input:
The transceiver detects numbers in the same block as identical.
The transceiver detects numbers in the same block as identical.
Therefore “01234” and “56789” are the same.
P0
P4
P3
P2
P1
*In this instruction manual, these keys are
from the left, called [P0]/[P1]/[P2]/[P3]/[P4].
KEY
P0
P1
P2
P3
P4
NUMBER
0
5
1
6
2
7
3
8
4
9
e
When the “PASSWORD” indication does not clear after
inputting 6 digits, the input code number may be incorrect.
Turn the power off and start over in this case.
Turn the power off and start over in this case.
n
Channel selection
Several types of channel selections are available. Methods
may differ according to your system set up.
may differ according to your system set up.
NON-ZONE TYPE:
To select the desired operating channel:
• Push [CH Up] or [CH Down].
• Rotate [CH Up/Down]*.
• Push one of [MR-CH 1] to [MR-CH 4].
To select the desired operating channel:
• Push [CH Up] or [CH Down].
• Rotate [CH Up/Down]*.
• Push one of [MR-CH 1] to [MR-CH 4].
ZONE TYPE:
To select the desired zone:
• Push [Zone], then push [CH Up] or [CH Down].
• Rotate [Zone Up/Down]*.
To select the desired zone:
• Push [Zone], then push [CH Up] or [CH Down].
• Rotate [Zone Up/Down]*.
AUTOMATIC SCAN TYPE:
Channel setting is not necessary for this type. When turning
power ON, the transceiver automatically starts scanning.
Scanning stops when receiving a call.
Channel setting is not necessary for this type. When turning
power ON, the transceiver automatically starts scanning.
Scanning stops when receiving a call.
*Simple type only