Справочник Пользователя для ICOM 349500
11
4
BASIC OPERATION
2
4
5
7
7
8
9
N Receiving and transmitting
CAUTION: Transmitting without an antenna may damage
the transceiver.
the transceiver.
Rotate
q
[VOL] clockwise to turn ON power.
s
s
Set the volume and squelch level.
w
± Push [
], and push [
Z] to open the squelch.
± Rotate [VOL] to set the volume level.
± Push [
], and push [
Y]/[Z] to set the squelch level.
Push
e
[
Y]/[Z] to select the desired channel.
s
- When receiving a signal, the “
” icon appears while audio is
heard from the speaker.
- Further adjustment of [VOL] may be necessary at this point.
Push
r
;(,s,/#+= to select the output power, if necessary.
- “LOW” appears when low power is selected; “MID” appears
when mid power is selected; no indication is displayed when high
power is selected.
power is selected.
- Choose low or mid power to conserve battery power; choose
high power for longer distance communications.
- Some channels are for only low transmission.
t Hold down [PTT] to transmit, and speak at your normal
voice level.
-
The
appears while transmitting.
- Channel 70 cannot be used for transmission.
Release
y
[PTT] to receive.
IMPORTANT: To maximize the readability of your transmit-
ted signal, pause a second after pushing [PTT]. Hold the
microphone 5 to 10 cm
ted signal, pause a second after pushing [PTT]. Hold the
microphone 5 to 10 cm
(2 to 4 inches)
from your mouth, and
speak at your normal voice level.
NOTE: The transceiver has a power save function to con-
serve the battery power. The power save function automati-
cally activates when no signal is received for 5 seconds.
serve the battery power. The power save function automati-
cally activates when no signal is received for 5 seconds.
To prevent accidental prolonged transmission, the trans-
ceiver has a time-out timer function*. This timer cuts OFF a
transmission after 5 minutes of continuous transmission.
ceiver has a time-out timer function*. This timer cuts OFF a
transmission after 5 minutes of continuous transmission.
* For only the USA and AUS versions.
q Power ON
w Set the volume
w Set the squelch
level
w Set the squelch
level
e Select the
channel
r Set the output
power
power
t Push to transmit
y Release to receive
Microphone
Speaker