Справочник Пользователя для ICOM 384700
– 4 –
– 1 –
Thank you for choosing this Icom product.
READ ALL PRECAUTIONS carefully and completely
before using this product.
1-1-32 Kamiminami, Hirano-ku, Osaka 547-0003, Japan
A-7383D-2EX
Printed in Japan
© 2017 Icom Inc.
PRECAUTIONS
VHF P25 TRANSCEIVER
Iç-F7520
UHF P25 TRANSCEIVER
Iç-F7510
WORD
DEFINITION
R
DANGER!
Personal death, serious injury or an explosion may occur.
R
WARNING!
Personal injury, fire hazard or electric shock may occur.
CAUTION
Equipment damage may occur.
NOTE
If disregarded, inconvenience only. No risk of personal injury, fire or electric shock.
R
WARNING! NEVER connect the transceiver to an AC
outlet. This may pose a fire hazard or result in an electric
shock.
R
WARNING! NEVER operate the transceiver during a
lightning storm. It may result in an electric shock, cause a
fire or damage the transceiver. Always disconnect the power
souce and antenna before a storm.
R
WARNING! NEVER connect the transceiver to a power
source of more than 16 V DC such as a 24 V battery. This
could damage the transceiver.
R
WARNING! NEVER cut the DC power cable between the
DC plug and fuse holder. If an incorrect connection is made
after cutting, the transceiver might be damaged.
R
WARNING! NEVER place the transceiver where normal
operation of the vehicle may be hindered or where it could
cause bodily injury.
CAUTION: NEVER expose the transceiver to rain, snow or
CAUTION: NEVER expose the transceiver to rain, snow or
any liquids.
CAUTION: CONFIRM that all connectors and jacks are
CAUTION: CONFIRM that all connectors and jacks are
dry and clean before attachment. Exposing them to dust or
water will result in serious damage to the transceiver.
DO NOT place or leave the transceiver in areas with
DO NOT place or leave the transceiver in areas with
temperatures below –30°C (–22°F) or above +60°C
(+140°F), or in areas subject to direct sunlight, such as the
dashboard.
DO NOT operate the transceiver without running the
vehicle’s engine. The vehicle’s battery will quickly run out
when the transceiver transmits while the vehicle’s engine is
OFF.
DO NOT place or leave the transceiver in excessively dusty
DO NOT place or leave the transceiver in excessively dusty
environments.
DO NOT place the transceiver against walls. Otherwise
DO NOT place the transceiver against walls. Otherwise
heat dissipation will be obstructed.
DO NOT use harsh solvents such as Benzine or alcohol
DO NOT use harsh solvents such as Benzine or alcohol
when cleaning, as they damage the transceiver’s surfaces.
BE CAREFUL! The transceiver will become hot when
BE CAREFUL! The transceiver will become hot when
operating continuously for long periods.
USE the specified microphone only. Other microphones
USE the specified microphone only. Other microphones
have different pin assignments and may damage the radio.
Place the radio in a secure place to avoid inadvertent use
Place the radio in a secure place to avoid inadvertent use
by unauthorized persons.
This transceiver has an air vent on the bottom panel of the
This transceiver has an air vent on the bottom panel of the
transceiver to meet the IP55 requirements.
BE CAREFUL! DO NOT block the air vent when installing
BE CAREFUL! DO NOT block the air vent when installing
the transceiver.
EXPLICIT DEFINITIONS
Icom is not responsible for the destruction or damage to
the Icom transceiver, if the malfunction is because of:
• Force majeure, including, but not limited to, fires,
earthquakes, storms, floods, lightning, other natural
disasters, disturbances, riots, war, or radioactive
contamination.
• The use of Icom transceivers with any equipment that is
not manufactured or approved by Icom.
PRECAUTIONS